Lucent Technologies Inc.

James Robert Lothian

Fan Ren

Minghwei Hong

Joseph Petrus Mannaerts

Alfred Yi Cho

William Scott Hobson

Jenshan Lin

The specification describes methods for making T-shaped metal gates for Schottky gate devices such as MESFETs and HEMTs. The method uses a bi-level photoresist technique to create a T-shaped feature for the gate structure. The metal gate is evaporated into the photoresist T-shaped feature and a lift-off process is used to remove unwanted metal. The photoresist is the dissolved away leaving the T-shaped gate. An important aspect of the process is the use of a plasma treatment of the first patterned resist level to harden it so that it is unaffected by the subsequent deposition and patterning of the second level resist.

Method of forming a T-shaped gate

A high quality oxide layer has been formed on a GaN surface by a method that involves preparation of the GaN such that the surface is essentially atomically clean and essentially atomically ordered, and that further involves exposing the surface to evaporant from a GGG (gallium gadolinium garnet) evaporation source. MOS structures comprising the GaN/oxide combination have shown low leakage current, as well as charge accumulation and depletion.

Article comprising an oxide layer on GAN

It has been found that a Ga-oxide-containing layer is substantially not etched in HF solution if the layer is a Ga-Gd-oxide with Gd:Ga atomic ratio of more than about 1:7.5, preferably more than 1:4 or even 1:2. This facilitates removal of a protective dielectric (typically SiO.sub.2) layer after an ohmic contact anneal, with the Ga-Gd-oxide gate oxide layer serving as etch stop and not being adversely affected by contact with the HF etchant. Gd-Ge-oxide also exhibits a composition-dependent etch rate in HCl:H.sub.2 O.

GaAs-based MOSFET, and method of making same

A thin conformal passivating dielectric film is deposited by ECR-CVD on an IC chip comprising semiconductor devices each of which includes a sub-micron-width irregularly shaped gate electrode. A protective layer of patterned resist is formed overlying each passivated device. Additional dielectric material is then deposited by ECP-CVD, at a temperature below the glass transition temperature of the resist, on the surface of the chip. Subsequently, in a lift-off step, the patterned resist together with the additional dielectric material overlying the resist is removed from the chip.

Growing community of inventors

Bethlehem, PA, United States of America

James Robert Lothian