General Electric Company

Current Lighting Solutions, LLC

Zsolt Bagoly

Jácint Gergely

József Fülöp

Peter Lucz

Gabor Schmidt

Tamás Vásárhelyi

Tamas Daranyi

Tímea Seszták

József Samu

Loránd Tóth

A lighting system waveform shaping circuit (WSC) includes a line voltage input, a line voltage output connectable to an input voltage port of a control unit, a neutral line input connectable to a neutral line of a voltage power source, and the WSC including an impedance matching network (IMN) configured to alter an input impedance of the lighting control circuit. In one embodiment, the IMN can include a resistor in series with the line voltage input, and an actively-controlled bypass switch in parallel with the resistor. In another embodiment, the IMN can include respective ferrite chokes surrounding the input and the output voltage lines, a capacitor between the line voltage input and the neutral line input, a capacitor between the neutral line input and a protected earth ground, and a resistor in series between the neutral line input and the lighting control unit neutral line input port.

Waveform shaping circuit for spurious harmonic suppression

A lamp includes a collar with internal and outer surfaces, where two or more connection pins extend from the internal surface of the collar. At least two connection pins have a head portion distal from the collar internal surface. The head portions include a slot. The lamp includes a light source with at least two external lead-in wires. The lead-in wires are located within respective slots and are mechanically coupled to respective surfaces of the slots in a press-fit manner which may be free of wrapping, winding, twisting, or soldering. A PCB disposed inside the lamp has two opposing surfaces and a rim between the two opposing surfaces. There are conductive surfaces disposed on at least one of the rim and one of the opposing surfaces at positions corresponding to connection pin slots. The PCB is located between connection pins with the conductive surfaces in electrical communication with the lead-in wires.

Device and method for coupling a light source to a printed circuit board in lamps

A fluorescent lighting device includes a ballast and a tube. An amalgam is located within the tube. A resistive heater is operatively coupled with the ballast, to receive electrical power from the ballast while the fluorescent lighting device is in an OFF state. The resistive heater is mounted near the amalgam to transfer heat to the amalgam while the fluorescent lighting device is in the OFF state.

Amalgam temperature maintaining device for dimmable fluorescent lamps

Growing community of inventors

Budapest, Hungary

Zsolt Bagoly