Hong Kong Applied Science and Technology Research Institute Company, Limited

Yunlong Li

Kwok Kuen (David) Kwong

Tat Fu Chan

Shiyuan Zheng

Lee L Yang

Wang Chi Cheng

Kwai Chi Chan

Weina Zhou

A Phase-Locked Loop (PLL) has a multi-curve voltage-controlled oscillator (VCO) with a curve-select input that adjusts the capacitance within the VCO and thus the VCO gain. A calibration unit generates a curve-select value to the VCO. Coarse calibration selects a Center Curve CC value using binary search of the curve-select bits. During fine calibration, the number of pulses of the VCO output are counted and stored for all curves in a target window around the center curve. The stored pulse counts are compared to an ideal pulse count for a specified frequency, and the curve-select value for the closest-matching pulse count is applied to the VCO. The target window is much smaller than all possible curves, so calibration is performed only on a few curves, reducing calibration time. A switch before the VCO opens the loop for faster open-loop calibration. Pulses are counted digitally without expensive analog comparators.

Fast coarse tune and fine tune calibration for a synthesizer by multi-curve calibration within a target window

A two-point modulation Phase-Locked Loop (PLL) has a gain-adjustable voltage-controlled oscillator (VCO). A digital data modulation signal is combined with a carrier and input to a feedback divider. The data modulation signal is also input to a Digital-to-Analog Converter (DAC) to generate an analog voltage to a second input of the VCO. A calibration unit divides the VCO output and counts pulses. During calibration, the data modulation signal is set to minimum and then maximum values and VCO output pulses counted. A count difference for the data modulation signal at maximum and minimum values is input to a Look-Up Table (LUT) to read out a gain calibration value. During normal operation mode, the gain calibration value from the LUT is applied to a second input of the DAC, which drives the VCO to adjust VCO gain. A switch before the VCO opens the loop for faster open-loop calibration.

Gain calibration for direct modulation synthesizer using a look-up table searched by a reduced count from an overflow counter

A transistor-based full-wave bridge rectifier is suitable for low A.C. input voltages such as received by a Radio-Frequency Identification (RFID) device. Voltage drops due to bridge diodes are avoided. Four p-channel transistors are arranged in a bridge across the A.C. inputs to produce an internal power voltage. A comparator receives the A.C. input and controls timing of voltage boost drivers that alternately drive gates of the four p-channel transistors with voltages boosted higher than the peak A.C. voltage. Four diode-connected transistors are connected in parallel with the four p-channel bridge transistors to conduct during initial start-up before the comparator and boost drivers operate. Substrates are connected to the power voltage on the power-voltage half of the bridge and to the A.C. inputs on the ground half of the bridge to fully shut off transistors, preventing reverse current flow. The transistor bridge can be integrated onto system chips.

Self-starting transistor-only full-wave rectifier for on-chip AC-DC conversion

A light-emitting diode (LED) driver provides faster rise and fall times for LED current to reduce image sticking and other interference. A standard DC-DC converter provides a sum current that is slowly ramped up and down by a bypass current digital-to-analog converter (DAC). A digital value to the bypass current DAC is ramped up or down before an LED current is turned on or off. When the LED current is turned on, current is shifted from a bypass path to a path through the LED, maintaining a constant sum current from the DC-DC converter. When a different LED is turned on, current is shifted from one LED's path to the other LED's path. Separate LED current DAC's in each LED path and in the bypass path can share the sum current with digital precision. Using a single DAC for the sum current and switches in each path reduces cost.

Growing community of inventors

Hong Kong, China

Yunlong Li