Mediatek Corporation

Mediatek Singapore Pte. Ltd.

Yung-Chih Yen

Patrick Stanley Riehl

Anand Satyamoorthy

Vladimir Alexander Muratov

Hasnain Akram

Chien-Wei Kuan

Hao-Ping Hong

Hung-Sung Li

Hung-I Wang

Alex Jianzhong Chen

Hung-chih Lin

Akram Hasnain

A multi-mode wireless power transmitter includes a first drive circuit of a first type and a second drive circuit of a second type. The first drive circuit is configured to drive a first transmit coil at a first frequency. The second drive circuit is configured to drive a second transmit coil at a second frequency higher than the first frequency.

Drive circuits for multi-mode wireless power transmitter

A resonant switched-capacitor converter is provided. The resonant switched-capacitor is configured to convert an input voltage on an input terminal of the resonant switched-capacitor converter into an output voltage on an output terminal of the resonant switched-capacitor converter. The resonant switched-capacitor converter includes a first resonant tank, a second resonant tank, a non-resonant capacitor, and a connection control circuit coupled to the input terminal, the output terminal, the first resonant tank, the second resonant tank and the non-resonant capacitor. The connection control circuit is configured to control connections of the first resonant tank, the second resonant tank and the non-resonant capacitor.

Resonant switched-capacitor converter

A wireless power receiver IC in which the power path can be reconfigured as either a low-dropout regulator (LDO), a switched-mode power supply (SMPS) or a power switch (PSW) is provided. All three modes share the same pass device to reduce die area and share the same output terminal to reduce pin. In an inductive wireless receiver, the power path can be reprogrammed on the fly to LDO or PSW mode or can be reprogrammed on the fly to SMPS or PSW mode. In a resonant or multi-mode wireless receiver, the power path can be reprogrammed on the fly to SMPS or PSW mode. Furthermore, to achieve high power transfer efficiency performance, using N-channel MOSFET as its pass device has better efficiency and smaller die area than P-channel MOSFET pass device.

Wireless power receiver with programmable power path

A synchronous rectifier using only n-channel devices in which the low-side switches are effectively cross-coupled using low-side comparators and the high-side switches perform an accurate zero-voltage-switching (ZVS) comparison. The charging path of each bootstrap domain is completed through the low-side switches, which are each always on for every half-cycle independent of loading. This scheme gives rectifier efficiency gain because a) each bootstrap domain receives maximum charging time, and b) the charging occurs through a switch rather than a diode. Both these factors ensure the bootstrap domain is fully charged, thereby reducing conduction losses through the rectifier switches. Furthermore, settings may be adjusted by software to optimize the resistive and capacitive losses of the rectifier. Using data for die temperature and operating frequency, software can create a feedback loop, dynamically adjusting rectifier settings in order to achieve the best possible efficiency.

A resonant wireless power (RWP) system is provided that includes a signal generator that provides an input signal waveform. An amplifier structure amplifies signals for transmissions to a receiver that is powered from a fixed DC voltage supply. The amplifier structure is operated either using differential or single-ended amplifiers to provide two different output power levels, in burst mode to provide a range of output power levels, or using a capacitor in a matching network that is adjusted to provide a range of output power levels.

Resonant wireless power driver with adjustable power output

A power converter includes a wave generator, a low pass filter, a first control circuit, and a second control circuit. The wave generator receives an input voltage, and converts the input signal into a wave signal according to a first control signal and a second control signal. The low pass filter filters the wave signal to generate an output voltage. The first control circuit generates the first control signal according to the wave signal and the output voltage. The second control circuit generates the second control signal according to the wave signal and the output voltage.

Power converter with a wave generator that filters a wave signal to generate an output voltage

A telescopic operational amplifier including a current source, an input stage, and a load stage is provided. The input stage is coupled to the current source and includes a group of input transistors for receiving an input voltage. The load stage is coupled to the input stage and includes a group of load transistors for outputting an output voltage. The threshold voltages of the group of input transistors are larger than that of the group of load transistors.

Growing community of inventors

Tainan, Taiwan

Yung-Chih Yen