National Chung Hsing University

Yu-Hung Li

Chien-Hung Liu

An external power supply system for spindles is revealed. The external power supply system includes a tool holder, a rectifier circuit, an overvoltage protection circuit. and a buck/boost converter. The tool holder receives an external power source of a spindle while the rectifier circuit converts the external power source into a rectified output signal with a power factor through step-down transformation. The overvoltage protection circuit is used to check whether the rectified output signal is larger than an overvoltage signal for outputting an operating potential or a non-operating potential. The buck/boost converter is used for receiving the rectified output signal with the power factor and converting the rectified output signal to an output voltage according to the power factor. Then the output voltage is provided to a load of a low voltage power supply, a high voltage power supply, or a constant voltage power supply.

Growing community of inventors

Changhua, Taiwan

Yu-Hung Li