Ebara Corporation

Yoshitaka Kitagawa

Hisajiro Nakano

Tomoatsu Ishibashi

Junji Kunisawa

A cover for a swing member of a substrate processing apparatus includes an upper surface including a first groove, and a first side edge and a second side edge located respectively at both ends of the upper surface in the short-length direction of the cover, where a bottom portion of the first groove is located lower than the first side edge and the second side edge.

Cover for swing member of substrate processing apparatus, swing member of substrate processing apparatus, and substrate processing apparatus

A substrate cleaning apparatus for bringing an elongated roll cleaning member into sliding contact with a flat plate type substrate to perform cleaning processing on the substrate includes a roll holder for supporting the roll cleaning member so that the roll cleaning member is rotatable, an elevating mechanism that has a linking member for supporting the roll holder, and moves the roll holder up and down so that the roll cleaning member applies a predetermined roll load to the substrate, a sensor member that is provided to the linking member and measures frictional force between the roll cleaning member and the substrate, and a controller for performing feedback control on the frictional force between the roll cleaning member and the substrate based on a measured value of the sensor member.

Growing community of inventors

Tokyo, Japan

Yoshitaka Kitagawa