Mitsubishi Jidosha Kogyo Kabushiki Kaisha

Yoshihiro Omi

Katsunori Ueda

Kazunori Handa

Masayuki Takagaki

Dairoku Ishii

Tatsuya Tawaki

Jun Aizawa

An ignition switch is turned on, and when an abnormality is detected in any of electronic control instruments or sensors, real failure is established, and a fail-safe process is performed. After a lapse of a predetermined period from the establishment of the real failure, fault determination is established, a failure level is sent, and a hybrid fail-safe process is performed. Then, when the abnormality is eliminated, the real failure is not established, and the fail-safe process of an engine is finished. Then, when the ignition switch is turned off and then again turned on, sending of the failure level to a hybrid control unit is stopped, and the hybrid fail-safe process is finished.

Control device for hybrid vehicle

Assumed torque Tb is calculated based on an operation state of an engine when there is no abnormality in sensors, the engine is in a warm-up completion state, and a travel mode is a series mode, and actual torque Ta is calculated and friction torque Tf is calculated based on information on an actual amount of electric power generation of a generator. When the friction torque Tf is larger than an upper limit clip value, the upper limit clip value is the friction torque Tf, and when the friction torque Tf is smaller than the lower limit clip value, the lower limit clip value is the friction torque Tf, correction torque Tc is calculated, and an operation of an electronic control instrument of the engine is controlled so as to set the assumed torque Tb to the correction torque Tc.

Growing community of inventors

Okazaki, Japan

Yoshihiro Omi