Central Iron and Steel Research Institute

Handan Xinxing Special Steel Pipes Co. , Ltd.

Yongqing Sun

Zhiyong Yang

Xiaohui Wang

Changjun Wang

Jianxiong Liang

Zhenbao Liu

Jie Gao

Fuqiang Liu

Ailiang Zhang

Yuguang Gao

A hot extrusion die for a special-shaped square pipe includes a die cavity sleeve with a special-shaped cavity. A hot extrusion mandrel is arranged in the die cavity sleeve. An area between the die cavity sleeve and the hot extrusion mandrel forms a die cavity hole. A first extrusion diversion hole and a second extrusion diversion hole are arranged below the die cavity hole. An integral centroid of the die cavity hole is located at a circle center of a radial cross section of the die cavity sleeve. Further disclosed is a hot extrusion integral forming method for a special-shaped square pipe, including: heating and expanding a blank material; heating the blank material again after expanding; performing hot extrusion on the blank material; and cooling the formed special-shaped square pipe in air to a room temperature, and inspecting surface quality and mechanical properties of the special-shaped square pipe.

Hot extrusion die and hot extrusion integral forming method for special-shaped square pipe

A high-strength stainless steel rotor and a method for preparing the same, are provided. The high-strength stainless steel rotor, including the following element components by mass percentage: C: 0.03-0.050%, Cr: 14.90-15.80%, Ni: 5.00-5.70%, Cu: 2.20-2.80%, (Nb+Ta): 0.35-0.44%, Mo: 0.45-0.54%, V: 0.06-0.10%, Si: 0.20-0.60%, Mn: 0.40-0.80%, P≤0.010%, S≤0.010%, O≤0.003%, and the balance of iron and inevitable impurities.

High-strength stainless steel rotor and method for preparing the same

Growing community of inventors

Beijing, China

Yongqing Sun