Ampower Technology Co., Ltd.

Amlink (shanghai) Ltd.

Yi-Hsun Lin

Tsung-Liang Hung

Cheng-Ta Lin

Li-Mei Chen

Chia-Hsin Tseng

Ming-Fu Chen

A system and a method for calibrating an ambient light sensor (ALS) are disclosed. The ALS, an adjustable resistor and a switch are located on a first surface of a printed circuit board (PCB), and the adjustable resistor and the switch are connected in series between an adjustable probe of the ALS and the ground. A resistor is connected between two pads located on a second surface of the PCB via two probes touching the pads. A controller connected to the PCB reads a light sensitivity of the ALS and calculates a calculated resistance value of the adjustable resistor by a formula 'detected light sensitivity/resistance value of the resistor=objective light sensitivity/resistance value of the adjustable resistor', wherein the objective light sensitivity and the resistance value of the resistor are given.

System and method for calibrating an ambient light sensor

A dual-lamp driving circuit includes a first frequency switch control circuit, a second frequency switch control circuit, a pulse-width modulation (PWM) control circuit, a first power stage circuit, a second power stage circuit, a conversion circuit, and a feedback circuit. The first frequency switch control circuit receives a first enable signal, and outputs a first frequency switch signal according to the first enable signal. The second frequency switch control circuit receives a second enable signal, and outputs a second frequency switch signal according to the second enable signal. The PWM control circuit outputs various PWM control signals according to the first frequency switch signal and the second frequency switch signal. The feedback circuit feeds back a first current signal from the first lamp to the frequency switch control circuit, and a second current signal from the second lamp to the frequency switch control circuit.

Dual-lamp driving circuit for liquid crystal displays

An inverter circuit drives a light source module. An input signal circuit provides electrical signals. A power stage circuit converts the electrical signals to square-wave signals. A transformer circuit converts the square-wave signals to alternating current (AC) signals capable of powering the light source module. A voltage detection circuit detects voltage applied on the light source module so as to output a detected voltage signal. A feedback circuit feeds current flowing through the light source module so as to output a current feedback signal. A protection circuit is connected to the voltage detection circuit and the feedback circuit, for outputting a latch signal according to the detected voltage signal or the current feedback signal. A pulse-width modulation control circuit outputs a switch signal to the power stage circuit according to the latch signal. The input signal circuit also provides the electrical signals to the protection circuit.

Growing community of inventors

Jhongli, Taiwan

Yi-Hsun Lin