Huawei Technologies Co., Limited

Yi-Hsiang Liao

Hanyang Wang

Yu Chan Yang

Dong Hai Yu

Jiaqing You

Chien-Ming Lee

Xiaoli Yang

Bin Yu

Bo Huang

Hideo Kato

Chien-ming Lee

Haowen Xu

Weihua Mao

Lizhong Huang

Yuchan Yang

Yanlei Ma

Guangxiang Zhu

A terminal device includes a housing and a metal line that is disposed on an outer surface of the housing or is embedded in the housing, and the metal line is configured to receive or send an electromagnetic wave signal. The metal line acts as an antenna of the terminal device.

Terminal device

A mobile terminal and a mobile terminal antenna production method. The mobile terminal uses an insulation film layer on an insulation rear housing as a carrier of a radiating element of an antenna, and the radiating element is located within the entire mobile terminal. A feed and an electric-conductor are disposed on a circuit board, and the electric-conductor is electrically connected to the feed. There is a gap between the radiating element and the electric-conductor, and the electric-conductor indirectly couples the radiating element in a capacitively coupled manner.

Mobile device radiating antenna disposed on an inner side of an insulation rear housing

A rotating shaft connection mechanism includes two rotating shafts, two connection assemblies corresponding to the two rotating shafts, and one synchronous driving block, where each connection assembly includes a slide rail block and a drive sheet, a boss of the slide rail block is inserted into a slanting groove on the drive sheet, the synchronous driving block is connected to the two rotating shafts, and the synchronous driving block is disposed on two sides of a connecting piece on the drive sheet by using provided connecting pieces, and is inserted into a spiral groove by using a provided positioning protrusion part. In this way, through fitting connection between the two rotating shafts, the one synchronous driving block and the slide rail blocks and drive sheets of the two connection assemblies corresponding to the two rotating shafts, rotation of the rotating shaft is converted into sliding of the slide rail block.

Rotating shaft connection mechanism and foldable device

A mobile terminal and a mobile terminal antenna production method. The mobile terminal uses an insulation film layer on an insulation rear housing as a carrier of a radiating element of an antenna, and the radiating element is located within the entire mobile terminal, thereby effectively increasing a height of the radiating element of the antenna relative to a circuit board with the antenna not affecting an appearance of the mobile terminal. Compared with a conventional support solution, this manner can increase a height of about 0.2 mm to 0.6 mm. This reduces an impact caused by a metal component on the circuit board on antenna radiation, and further increases a bandwidth and efficiency of the antenna so that the antenna can cover a frequency band used in a handheld communications system.

Mobile terminal and mobile terminal antenna production method

Growing community of inventors

Shenzhen, China

Yi-Hsiang Liao