Huawei Technologies Co., Limited

Xueqi Chen

Yan Zhuang

Shiyong Fu

Rui Hua

Jincan Cao

Fuguang Huang

Haifei Wang

Xiangen Xu

Yu Ding

Jianguang Yang

Qi Dong

A network device includes a power system, a processor, a power sourcing equipment PSE chip coupled to a first forward power supply port, and a first powered device PD chip coupled to a first reverse power receiving port. A first powered device is connected to the first forward power supply port and the first reverse power receiving port. When detecting that a power failure occurs on the network device, the processor instructs the first PD chip to draw power from the first powered device; the first PD chip draws the power from the first powered device through the first reverse power receiving port, and supplies the obtained power to the power system. Therefore, when a power failure occurs, the network device can continue to obtain power and work properly when the power failure occurs.

Network device and power supply method

A power supply management method performed by power sourcing equipment, includes receiving a power-on request from a level-1 powered device, where the power-on request includes a port identifier of a level-2 power supply port that is detected to be valid in the level-1 powered device, determining, based on the power-on request and an outputtable power of the power sourcing equipment, a level-2 power supply port that is allowed to be powered on in the level-1 powered device, and sending a power-on instruction to the level-1 powered device, where the power-on instruction includes a port identifier of the level-2 power supply port that is allowed to be powered on in the level-1 powered device. The power sourcing equipment uses the level-1 powered device and a level-2 powered device connected to the level-1 powered device as a whole, and centrally performs power supply control and power management.

Power supply management method, device, and system

Power sourcing equipment for power over Ethernet (PoE) includes a power supply control circuit, an Ethernet port, and a surge protection circuit. The surge protection circuit includes a first circuit, a second circuit, and a common discharge circuit. The first circuit is connected to a power supply pin group of the Ethernet port, the power supply control circuit, and the common discharge circuit. The second circuit is connected to a non-power supply pin group of the Ethernet port and the common discharge circuit. The first circuit transmits, to the common discharge circuit, a first surge that is input from the power supply pin group. The second circuit transmits, to the common discharge circuit, a second surge that is input from the non-power supply pin group. The common discharge circuit discharges the first surge and the second surge to ground.

Power sourcing equipment and power over ethernet system

A power over Ethernet method includes: performing, by power sourcing equipment, a plurality of detections by using an Ethernet port, connected to an intermediate device, of the power sourcing equipment, where a quantity of detections performed by the power sourcing equipment is equal to a quantity of power supply ports of the intermediate device; and if at least one detection result of the plurality of detections is effective, sending, by the power sourcing equipment, a power supply indication to the intermediate device, and supplying power to the connection port. In this way, the power sourcing equipment can supply power across the intermediate device to a powered device connected to the intermediate device, and a power loss caused by voltage conversion is avoided.

Power supply method, device, and power supply system

A power sourcing equipment (PSE) chip, and a Power over Ethernet (PoE) device and method are provided, which can determine a status that a peer end is connected to a powered device (PD) when four cable pairs are used to supply power. The PSE chip includes a channel controller, a first channel detector, and a second channel detector. The channel controller sends detection voltages along a first and a second groups of cable pairs in an Ethernet twisted pair; determines a first impedance and a second impedance according to the detection voltages and corresponding currents that are detected; and determines that a first group or a second group of cable pairs is connected to a valid PD according to the impedances and a preset range.

Growing community of inventors

Nanjing, China

Xueqi Chen