Fsi International, Inc.

Fsi Corporation

William M Jenson

Robert W Grant

A fluid dispensing and metering unit is described for dispensing fluids into a system without the introduction of microcontaminants into the fluid flow. This unit includes a block with a fluid conducting duct axially extending from the block's proximal face to the block's distal face. In communication with the fluid conducting duct is a combined dispensing and modulating means for regulating the amount of fluid entering the fluid conducting duct. A plurality of these units can be assembled to construct a flow control manifold, creating a single continuous duct for carrying all dispensed fluids.

Flow control manifold

A cover for a fluid processing chamber is formed of a resilient, heat and chemical resistant laminate of at least three layers. The first layer is a Teflon sheath, the second layer is a blanket heater, and the third layer is a plurality of thin sheets of silicone rubber. The laminate is formed by vacuum formation of the Teflon sheath onto the blanket heater which is supported by the silicone rubber. The opening to the chamber is formed with a rigid lip. The laminate is contained in a stainless steel housing which has an opening therein sized to encompass the perimeter of the chamber lip. Pressure on the cover housing achieves a fluid tight seal with the chamber. No fluid seeps between the cover and the lip even when processing requiring vigorous fluid agitation is carried out in the sealed chamber.

Growing community of inventors

Excelsior, MN, United States of America

William M Jenson