Siemens Energy, Inc.

William J Lowe

Somesh J Ghunakikar

Mark A Garcia

Hang Li

A method for holding a sintering filler material during a brazing/sintering operation for repairing a damaged area of a component wherein the component is in either a bonding face down position, bonding face vertical position or bonding face up position. The method includes providing a wire mesh and attaching the wire mesh to the component in a location corresponding to the damaged area. Further, the method includes forming a gap between the wire mesh and the component. Moreover, the sintering filler material may be inside the wire mesh or both inside and outside the wire mesh in order to secure the sintering filler material to the damaged area.

Method for holding brazing material during a brazing operation

A process for repairing combined heavy erosion and thermal fatigue cracks and/or other defects, such as large cracks, in a high temperature superalloy component, such as a vane in a turbine section of a gas turbine engine, that does not require mechanical grinding to prepare the defect site. The process includes depositing a loose finely granulated superalloy powder or a low viscosity superalloy slurry in the crack up to a suitable level and then depositing a superalloy putty layer on the superalloy powder or slurry at the top of the crack A braze putty layer is then deposited over the superalloy putty layer and the component is sintered in a vacuum furnace to harden the superalloy putty and powder or slurry to repair the defect.

Growing community of inventors

Pfafftown, NC, United States of America

William J Lowe