Baker Hughes Corporation

Baker Hughes Oilfield Operations LLC

Walter Chapman

James H Holt

Keith E Lewis

Joseph C H Yeo

Anthony James Orchard

Jim H Kritzler

Vimal Vinod Shah

Jinfeng Zhang

Victor Jose Acacio

James H Kritzler

Jeffrey L Osselburn

Jewell Cope

A production well includes a casing and encapsulated tubing positioned within the casing. The encapsulated tubing includes a conductive sidewall defining a channel for an injection fluid. The production well further includes an insulative layer surrounding the conductive sidewall. The production well also includes a controller configured to regulate flow of an electrical current through the conductive sidewall. The production well further includes production tubing positioned within the casing and configured to channel a production fluid through the casing. The insulative layer is configured to inhibit transmission of the electrical current between the conductive sidewall and the production tubing. The production well also includes at least one sensor positioned within the casing to detect downhole conditions of the production well. The conductive sidewall is configured to conduct electrical current toward the at least one sensor.

Methods and systems for downhole sensing and communications in wells

In systems and methods for production of hydrocarbons fluids from a formation surrounding a wellbore, a production assembly is cemented into place, and excess cement is then cleaned from the production tubing and liner. Thereafter, hydrocarbon fluids are produced and artificial gas lift assistance is provided. All of this may be accomplished in a single trip (mono-trip) of the production tubing.

Mono-trip cement thru completion

Well completion cement may be pumped through a side pocket mandrel that includes parallel rows of filler sections to exclude cement from void space within the side pocket tube. The filler sections are drilled with cross-flow jet channels and surface upsets to stimulate scrubbing turbulence by well working fluid behind a cement wiper plug. The wiper plug includes leading and trailing groups of wiper discs secured to an elongated shaft. The two wiper groups are separated by a distance that permits the leading seal group to gain traction seal before the push seal on the trailing wiper group is lost. A spring centralizer spans a center section of the shaft between the two wiper groups to maintain axial alignment of the shaft as the plug traverses the length of a mandrel.

Cement through side pocket mandrel

Growing community of inventors

Kingwood, TX, United States of America

Walter Chapman