Rockwell Automation Technologies Incorporated

Timothy J Strandt

Alan J Campbell

Garron Koch Morris

Jianfeng Wu

Daniel Joseph Middlestetter

Zeljko Radomir Jankovic

Al J Campbell

Junsheng Mu

Yiqing Lin

Jason H Downing

Divesh Sachdeva

Haochen Zhu

Tongxi Wu

Thermal monitoring and analysis of conditions in a power electronic system include sensing of thermal parameters of interest, such as temperature and humidity in an enclosure housing power electronic components. The components are cooled by a liquid coolant flow from a chiller through chiller plates associated with the power electronic components. Air is circulated through the enclosure for heat rejection from the chiller plates. Based on the sensed parameters, factors such as relative humidity and dew point of the cooling air may be computed and evaluated to determine the potential for condensation. Alarms, notices, or recommendations may be output for regulation of the chiller to avoid condensation. The system may also provide for evaluation of installation errors, and degradation of performance over time.

Power electronic cooling system and method

A disconnect override circuit for a power conversion system includes a first input coupled to a user disconnect switch to receive a disconnect input signal, as well as a second input coupled to a motor drive or motor starter to receive a fault signal, and a third input adapted to receive an override signal. The disconnect override circuit has an output configured to provide a disconnect control output signal to control a user disconnect circuit according to the disconnect input signal, the fault signal and the override signal, the output signal having a first state to cause the user disconnect circuit to allow power transfer from the AC input to the motor drive or motor starter, and a second state to cause the user disconnect circuit to prevent power transfer from the AC input to the motor drive or motor starter.

Embedded electronic motor disconnect

A method may include receiving, via a processor, a request to enable movement of a rotor. The method may involve sending a first signal to a mechanical relay system in response to receiving the request, such that the second signal may cause a mechanical relay to close. The mechanical relay system is configured to couple a first conductor to an EM brake. The method may also include sending a second signal to a solid-state relay system after sending the first signal to the mechanical relay system, such that the second signal may cause a solid-state relay to close. The solid-state relay system may couple a second conductor to the EM brake, such that the EM brake may open after receiving power via the first conductor and the second conductor.

Extending the life of electromagnetic brake control circuits

Growing community of inventors

Mequon, WI, United States of America

Timothy J Strandt