Schott Ag

Thorsten Wilke

André Witzmann

Robert Frost

Christian Mix

Johann Faderl

Ernst-Walter Schaefer

Uwe Nolte

Otmar Schmittel

Christopher Fritsch

Florian Berger

Ina Filbert-Demut

Rupert Fehr

A unit for high-temperature for uses above 700° C. is provided. The unit includes a housing and an electrical functional element. The functional element has a non-conducting substrate, an electrically conductive element, and at least one connection wire or pad. The functional element has a first section, a second section, and a third section. The first section is within the housing and shielded from a local environment. The second section includes the at least one connection wire or pad and is accessible externally to the housing. The third section is between the first and second sections and is embedded in an electrically insulating material. The insulating material seals off the housing from the functional element. A physical and/or chemical bond at an interface between the insulating material and the functional element.

Unit for high-temperature uses

A method for controlling alkali emissions of a glass element during hot forming is provided. The method includes the steps of: heating the glass element using one or more burner units each providing a burner flame to provide a heated glass element; sensing light emissions of a total light emitting area of the heated glass element and the burner flame of the one or more burner units via one or more sensor units; providing one or more signals of the one or more sensor units of the light emissions; comparing the one or more signals with one or more reference signals; determining, based on the comparing step, determined alkali emissions of the glass element; and controlling the one or more burner units based on the determined alkali emissions to adjust the alkali emissions of the glass element to a pre-given interval.

Method for controlling alkali emissions of a glass element during hot forming

The method measures the thickness of a hot glass body without direct contact with the glass body and is based on chromatic aberration. This method includes focusing a light beam from a light source on the hot glass body using a focusing device immediately after formation; conducting reflected light from the glass body into a spectrometer to obtain a reflected light spectrum; finding two wavelengths of the reflected light from the front side and the rear side of the glass body respectively at which reflected light intensities are maximum; determining the thickness of the glass body from the difference between the two wavelengths; maintaining the focusing device at a temperature below 120&#xb0; C. during the measuring of the thickness and substantially preventing heat radiation from reaching the focusing device using at least one heat-blocking filter.

Method and apparatus for contactless optical measurement of the thickness of a hot glass body by optical dispersion

Growing community of inventors

Munich, Georgia

Thorsten Wilke