Eaton Corporation

Thomas Michael Doring

Kevin Lee

Ian Wallace

Ralph Mason Ennis

Jyrki K Ahlgren

Joseph C Engel

Kevin Anthony Simms

Wayne Gerald Adamson

A motor drive for conditioning power to be delivered to a non-motor load includes a voltage feedback circuit that monitors a DC bus voltage and, based on changes in the DC bus voltage, adjusts a power conditioning scheme such that near steady-state load conditions are maintained in response to a transient load condition. The voltage feedback circuit has a voltage sensor that provides voltage feedback to a controller that determines what changes in power conditioning are needed in response to a transient load condition that manifests itself in a change in DC bus voltage.

System and method of controlling power to a non-motor load

A motor drive for conditioning power to be delivered to a load includes a current feedback circuit that monitors current being fed to a transformer connected between the motor drive and the load. Based on the total current input to the transformer, a controller adjusts the V/Hz profile along which the motor drive operates. In this regard, the motor drive operates according to a V/Hz profile during start-up that prevents transformer saturation.

System and method of controlling the start-up of an adjustable speed motor drive based sinusoidal output power conditioner

A thermal detection system () contains a plural pole circuit breaker () and a resistance temperature detector adhesive tape () connected to an electric circuit () that detects the resistance change in the adhesive tape (), which in turn sends a signal to a shunt trip () connected to the circuit breaker ().

Bus bar thermal detection

A tester for an arc fault circuit breaker plugs into a socket in the protected branch circuit. An actuator includes a first spring biasing a moveable contact carried by a pivoted contact arm away from a fixed contact and a momentary closer for momentarily closing the contacts. The momentary closer includes a push button and a second spring coupling the push button to the pivoted contact arm to close the contacts when actuated. Closing of the contacts completes a circuit across the branch circuit resulting in a current producing a magnetic repulsion force which blows the contacts open thereby striking an arc. The arc, which should trip the arc fault circuit breaker is visible through a translucent or transparent section of the molded tester housing. A fuse interrupts any overcurrent and a test light verifies initial energization of the protected circuit and operation of the arc fault circuit breaker.

Apparatus for testing protection of an electric power distribution

A two pole circuit breaker having arc fault and ground fault protection circuits, in addition to a standard thermal-magnetic trip units, that is designed to fit in a standard knock-out, three-quarter inch or one-inch, of a circuit breaker load center panel. The circuit breaker is divided into three compartments with two side-by-side compartments housing the electro-magnetic trip mechanism respectively for each pole, and a third compartment in tandem with the other two for housing the electronics associated with the ground fault and arc fault protection circuits. The circuit breaker spans the area allocated to a single knock-out with portions of the electro-magnetic trip compartments seated within the knock-out opening and with the third compartment hidden behind the panel.

Growing community of inventors

Wexford, PA, United States of America

Thomas Michael Doring