Robert Boschgmbh

Volkswagen Ag

Seg Automotive Germany Gmbh

Thomas Koss

Guenter Nasswetter

Helmut Suelzle

Gerhard Fiedler

Michael Herz

Richard Schleupen

Walter Kohl

Tomasz Bachorski

Egon Reisz

Arnold Engber

Lothar Jakobi

Xaver Laufenberg

Olaf Lengfeld

A method for operating a generator for an internal combustion engine of a vehicle having a starting operating mode and a start-stop operating mode, a torque of the generator being delimited in the starting operating mode, including: detecting an operating mode of the vehicle, and deactivating a delimitation of the torque of the generator if the detected operating mode corresponds to the start-stop operating mode.

Method and device for operating a generator

A device for detecting a change in a generator output signal of a vehicle generator includes a window comparator for comparing a signal amplitude of the generator output signal to at least one threshold value which limits a signal amplitude range, a detector for detecting a change in the generator output signal based on an output signal of the window comparator, a detection unit for detecting a signal amplitude difference between a maximum signal amplitude and a minimum signal amplitude of the generator output signal, and an adaptation unit for adapting the signal amplitude range of the window comparator, based on the signal amplitude difference, when there is the change in the generator output signal.

Device for detecting a change in a generator output signal of a vehicle generator

A generator device with a generator regulator and a generator unit having a generator and a rectifier arrangement. The generator regulator has an operating voltage connection and a phase voltage connection. Furthermore, if during a control intervention of the phase voltage the DC voltage applied to the operating voltage connection exceeds a predefined limit for a predefined period of time, the generator regulator deactivates the control intervention of the phase voltage.

Generator device with overvoltage monitoring

The method of transmitting data as a sequence of high bits and low bits over a transmission line from a transmitting device to a receiving device includes transmitting synchronization signals over the transmission line and transmitting one and only one high bit or one and only one low bit over the transmission line at an end of each synchronization signal. When the predetermined voltage levels for the high bit, low bit and synchronization signals are different from each other, the method is implemented in an especially simple manner. The interfaces for the receiving and transmitting devices for performing the method are also described.

Data synchronisation process, and transmission and reception interfaces

A voltage regulator for a generator drivable by an internal combustion engine is proposed, in which the triggering of the end stage transistor for varying the exciter current is done with the aid of a pulse width modulator. The digital pulse width modulator employed is a component of a closed-loop control circuit for the exciter current, which uses the generator voltage as the actual value and regulates the pulse width ratio duty factor as a function of the generator voltage detected, and in addition a system damping is performed, in that one entire period of the duty factor can be turned off in overriding fashion. This overridingly turned-off period can be adapted in its duration to the duty factor, thus resulting in a voltage change that is independent of the duty factor. The maximum current rise rate can thus be limited by limiting the maximum rate of change of the pulse width modulator.

Voltage regulator for a generator drivable by an internal combustion engine

Generator regulator with overload protection means

Controller with phase voltage evaluation for a three phase generator

The analysis or evaluation circuit for analyzing an alternating voltage or current signal that includes a D.C. voltage or D.C. current component includes a window comparator having a circuit portion for comparing the alternating voltage or current signal to an upper threshold and a lower threshold and another circuit portion for adjusting the upper and lower threshold when one of the upper and the lower thresholds is reached by the alternating voltage or current signal. By means of a VCL output signal that switches when a threshold adjustment occurs, a frequency dependent signal may be produced that can be analyzed to obtain a rotational speed of a rotational body from which the input alternating voltage or current is derived.

Device for analyzing an alternating voltage or current including a

Growing community of inventors

Reutlingen, Germany

Thomas Koss