Motorola Corporation

Thomas F Karlmann

Adelore F Petrie

Randall C Gray

Arthur J Edwards

Steven G Parmelee

An improved dual limit solenoid driver control circuit is disclosed in which solenoid current is sensed and provided as an input to two separate comparators (24, 25). Each comparator receives, during a solenoid pull-in (initial) period (T.sub.1), fixed maximum and minimum reference threshold levels which determine the maximum and minimum current limits (I.sub.max, I.sub.min) for solenoid current during initial pull-in excitation. Subsequently during a hold period T.sub.2 following the pull-in period, each of the comparators receives different maximum and minimum thresholds so as to establish holding solenoid current limits (H.sub.max, H.sub.min). The outputs of the compartors are connected as inputs to a set/reset flip flop (32) whose output controls the operation of a solenoid driver circuit (15). A monostable multivibrator (33) reacts to an initial control pulse (41) to produce a predetermined pull-in time pulse (43) that results in the maximum and minimum pull-in solenoid current limits. The comparator thresholds are provided by a fixed resistor divider circuit (27, 29, 31) which receives a pull-in signal from the monostable multivibrator. The pull-in period (T.sub.1) is independent of the sensed solenoid current, and the switching thresholds are fixed and independent of the magnitude of the solenoid current during the pull-in and hold periods. The above configuration provides improved performance and stability, and is readily implemented with just a few components.

Dual limit solenoid driver control circuit

In a solenoid fuel injection system, an output transistor (16) receives switching signals to control through current therein which is provided to a solenoid fuel injection coil (11) in series with a current sensing resistor (17). A current control circuit (12) provides pulse width modulation control of solenoid current by monitoring the voltage across the sensing resistor. The fault detection circuit provides separate fault signals for short circuits at either the first or second end terminals (E, H) of the solenoid coil. Separate voltage comparators (18, 23) monitor voltages at the first and second end terminals, and separate delay timers (20, 25) effectively gate the comparator outputs to indicate actual detected short circuits. Each of the fault detection signals sets a fault latch (22) which then acts to reduce current through the output transistor and coil. The fault latch is periodically reset. For a fault detection, the output transistor is protected from excessive current resulting from a short circuit at one end terminal (H). The transistor and coil are also protected from a short circuit at the other end terminal (E) which results in the lack of a current sense signal causing the controller (12) to attempt to maintain the output transistor constantly on.

Growing community of inventors

Schaumburg, IL, United States of America

Thomas F Karlmann