Honda Motor Co., Ltd.

Honda Giken Kogyo Kabushiki Kaisha

Theodore Klaus

James W Post, Ii

Xiaodi Kang

A cooperative traction control system wherein individualized control over each wheel's longitudinal slip and/or lateral skidding is provided. The system uses a combination of an existing traction and stability module linked with a drive torque actuator capable of modulating the amount of drive torque at a given wheel on a specified axle. The system permits drive torque at the slipping and/or laterally skidding wheel to be controlled, either alone or in combination with brake actuation and throttle angle control, to reduce or control wheel slip and/or lateral skid and/or vehicle motion.

Cooperative traction control system

A feed forward method for controlling the distribution of torque between the front and rear axle in a four wheel drive vehicle where the slope of a hill upon which the vehicle is traveling is calculated based on measured vehicle longitudinal acceleration and estimated longitudinal acceleration. The hill slope estimation is made and implemented before the wheels of the vehicle begin to slip due to the slope and low friction coefficient of the road surface. Under conditions of high vehicle speeds or severe vehicle turning, the change of torque distribution is not implemented because there is a lesser tendency for the vehicle to slip on the hill surface.

Detection of hill grade and feed-forward distribution of 4WD torque bias to improve traction on a low MU surfaces during climbing of such hill grade

A method and system for performing the method of controlling vehicle braking where the wheel slip of individual vehicle wheels is calculated and the load upon individual vehicle wheels is determined. A first brake line correction factor is calculated based on the determined loads upon the vehicle wheels. A second brake line correction factor is calculated based on the calculated wheel slip and the first and second load brake line correction factors are used to modulate a pressure supplied to individual wheel calipers during braking of the vehicle.

Method for vehicle braking control utilizing dynamic force proportioning based on wheel loads

A method and system for inhibiting torque steer in a vehicle equipped with steerable wheels that are power driven. The method determines a maximum engine torque limit, determines an estimated driver-desired torque, and controls the actual torque, by adjustment of the throttle angle, to be the smaller of the maximum engine torque limit and the estimated driver-desired torque. Sensors measure steering angle and transmission gear position and a calculator determines the maximum engine torque limit based upon the steering angle and transmission gear position. Further sensors measure engine speed, throttle angle, and atmospheric pressure, and a calculator estimates driver-desired torque based upon the measured engine speed, throttle angle, and atmospheric pressure. A comparator selects the lower of the maximum engine torque limit and the driver-desired engine torque and uses the selected torque to control throttle angle to inhibit torque steer.

Growing community of inventors

Marysville, OH, United States of America

Theodore Klaus