Honda Motor Co., Ltd.

Keihin Corporation

Yokogawa Electric Corporation

Takuya Yahagi

Hiroshi Ito

Takashi Hisaki

Shigeki Baba

Yoshihisa Hidaka

Kensuke Yamamoto

Shigeru Takezawa

Youichiro Shikine

Akihito Inoue

Shuji Tomimatsu

Satoshi Arai

Tomohide Ichikawa

A multi-component gas analysis system includes a spectrometric analysis device configured to obtain ratio of each of first components in a multi-component gas based on an absorption spectrum of light that has transmitted through the multi-component gas; a density measurement device configured to measure a first density of the multi-component gas; and a calculation device configured to calculate a ratio of each of second components in the multi-component gas using the ratio of each of the first components obtained by the spectrometric analysis device and the first density measured by the density measurement device, the second components being components that cannot be obtained by the spectrometric analysis device.

Multi-component gas analysis system and multi-component gas analysis method

A valve control device includes a drive circuit for supplying a drive signal to an actuator adjusting an opening degree of a valve via a prescribed transmission line, generates a PWM signal on the basis of a target opening degree supplied from the outside and a sensor signal that indicates a real opening degree of the valve, and supplies the PWM signal to the drive circuit. The valve control device includes a disconnection detection unit which detects, on the basis of the PWM signal and a monitor signal of the drive signal, whether the transmission line is disconnected.

Valve control device and valve system

A starter drive device which drives a starter motor by, upon actuation of a starter switch, turning a starter relay ON and OFF via an electronic control device, wherein the electronic control device includes: an interface circuit; a power source control circuit; a calculation device and a delay circuit; a buffer; an addition circuit; a latch circuit; a first pull up circuit; a second pull up circuit; and wherein, if the power source control circuit has detected a drop of voltage of the power source when the starter motor is being driven, along with stopping the calculation device, the buffer disconnects the calculation device from the latch circuit, and controls the starter relay by operating the driver circuit via the latch circuit based upon the signals from the interface circuit and the second pull up circuit.

Starter drive device

Growing community of inventors

Tokyo, Japan

Takuya Yahagi