Kubota Corporation

Takuji Mori

Shiro Takada

Akira Nakamoto

Taro Saito

Mutsumi Sunahata

Akiyoshi Hanazawa

Kazunori Sakunaga

A method for zero correction in torque sensors, such as magnetostrictive torque sensor and strain gauge type torque sensor. Torque measurement is initiated when absolute values of torque signals are greater than a first set value, sampling measurement is carried out at predetermined intervals after the initiation. After absolute values of the measured torque signal values become lower than a second set value, an average value for a predetermined number of torque signal values whose absolute values are lower than a third set value is set as a new zero. The method permits proper measurement and correction of zero signals from torque sensors employed succesively at locations subject to impulse-like action of a torque load.

Method for zero correction in torque sensor

A torque measuring system can detect the magnitude of a torque applied to a torque sensing shaft and output a torque signal with respect to the torque. A torque sensor of the system has a measurement mode for producing torque signals and a correction mode for correction of its detection characteristics. An external signal for selection of one of the two modes is supplied to the torque sensor by a characteristic check device. The correction mode enables the correction of the torque sensor characteristics to be effected accurately and in a short time period without requiring manual labor.

Torque measuring system

Growing community of inventors

Yao, Japan

Takuji Mori