Nippon Steel Corporation

Taketoshi Taira

Yoshio Shindou

Kaoru Kawasaki

Kazuo Koyama

Joji Oka

Atsushi Itami

Fumio Yamazaki

Yujiro Miyauchi

Nobuhiko Matsuzu

Shirou Fujii

A one-side electrogalvanized steel sheet with a distinguished susceptibility to a phosphate salt treatment and a distinguished appearance on the non-electrogalvanized side is produced by subjecting the non-electrogalvanized side of a steel sheet after one-side electrogalvanization in a galvanizing bath to an electrolytic peeling treatment using the non-electrogalvanized side of the one-side electrogalvanized steel sheet as an anode in an electrolytic peeling treatment bath containing 5 to 30% by weight of sodium sulfate as an electroconductive agent and at least 0.1% by weight of boric acid as a pH-controlling agent at a pH adjusted to a range of 5.0 to less than 9.0 as a posttreatment of the non-electrogalvanized side.

Process for producing one-side electrogalvanized steel sheet with

A process for producing a cold-rolled high strength steel sheet having an excellent formability and conversion-treatability, comprising the steps of: heating to a temperature of 1150.degree. C. or lower, a steel slab comprising; 0.005 wt % or less of C, 0.5-1.5 wt % of Si, 0.1-0.5 wt % of Mn, 0.003-0.05 wt % and at least 3.4.times.N wt % of Ti, 0.003-0.05 wt % and at least 7.8.times.C wt % of Nb, 0.01-0.1 wt % of Al, 0.05-0.15 wt % of P, 0.010 wt % or less of S, 0.005 wt % or less of N, 0.0001-0.0050 wt % of B, the balance consisting of Fe and unavoidable impurities; hot-rolling the steel slab with a finishing rolling temperature of the A.sub.r3 point of the steel or higher to obtain a hot-rolled steel sheet; cooling the hot-rolled steel sheet at a cooling rate of 10.degree. C./sec or more in the stage between said finishing rolling and the following coiling step, with the provision that said cooling is started not later than 2 sec after the hot-rolling is finished and is continued for a duration of at least 3 sec; coiling the steel sheet at a temperature of 650.degree. C. or higher; cold-rolling the steel sheet at a usual rolling draft; and continuous-annealing the cold-rolled steel sheet at a heat-cycle of holding for 1 sec or longer at a temperature of 930.degree. C. or lower to complete the recrystallization of the cold-rolled steel sheet.

Process for producing cold-rolled high strength steel sheet having

A weldable steel plate plated with zinc, a zinc base alloy or zinc composite and coated on the plating with a coating material comprising a mixture of at least one type of ferrous alloy powder with an oxygen concentration of 1.0% by weight or less and zinc dust, is provided, and the weldable coated steel plate also has good workability, coherence, weldability and corrosion resistance.

Anticorrosive weldable coated steel

Growing community of inventors

Kimitsu, Japan

Taketoshi Taira