Honda Motor Co., Ltd.

Japan Atomic Energy Research Institute

Power Reactor and Nuclear Fuel Development Corporation

Takeshi Okada

Atsushi Yamashita

Susumu Isobe

Tatsuo Kondo

Hajime Nakajima

Taiki Kobayashi

Yasukazu Ishida

Katsutoshi Watanabe

A cold flake suppression method is provided. A molding device includes a sleeve, a tip, a sprue guide portion, a molding die, a sprue ring, a distributer, and a control device. The sprue guide portion includes a stamp portion, a runner portion, and a gate portion. The control device drives a supply device to slide the tip for molten metal to flow through the sleeve; sequentially calculates an amount of heat transfer changing continuously from the start of supply of molten metal until the tip slides to the position in FIG., and calculates a total of the amounts as a total amount of heat transfer; and calculates a volume of the sprue guide portion based on information about the sprue guide portion input by an operator. Shapes of the sleeve and the sprue guide portion are determined to set a cold flake index equal to or less than 0.842.

Cold flake suppression method

A solid solution strengthened iron-base austenitic alloy is suitable for use in nuclear reactors having low oxidizing environment. It has a composition of 8 up to but not including 16.0% by weight of Cr, 14-35% by weight of Ni, 5-15% by weight of Mo plus 0.522 W, up to 1.0% by weight of Ti, up to 2% by weight of Mn, up to 1% by weight of Si, up to 0.1% by weight of C and the balance iron and unavoidable impurities.

Solid solution strengthened iron-base austenitic alloy

Growing community of inventors

Tokyo, Japan

Takeshi Okada