Denso Corporation

Takashi Takata

Tokuhisa Takeuchi

Nobukazu Kuribayashi

Masahiko Sugaya

An alcohol detection system for a vehicle has an alcohol sensor, for which alcohol measurement preparation processing such as heating the alcohol sensor to a predetermined temperature is performed, so that the alcohol sensor operates under the stable operation state. The alcohol measurement preparation processing is started, before a driver actually gets in the vehicle. For example, the preparation processing is started, when a predetermined manipulation of a driver on the vehicle before entering the vehicle is detected. The manipulation may be unlocking or opening of a vehicle door.

Alcohol detection system and method for vehicle

An actuator, operated by being supplied with electric power, needs an initial setting for performing a desired operation by recognizing its starting position. The initial setting is conducted when an abnormality occurs in a signal which represents an operation of the actuator. The initial setting is also conducted when a system for the actuator recognizes a fact that a battery is electrically disconnected in association with information denoting a condition of the battery in a memory.

Electrically-operated actuator system

In determining a starting point of a motor of an electric actuator during its initialization procedure, when a rotation angle sensor detects pulse signals in a certain initialization pattern, power supply to the motor is stopped by the control of a motor drive circuit. This electrical control of motor rotation enables the initialization procedure of the actuator to be carried out without using mechanical restriction means for locking purposes, and the influence of variations in the deflection amount of any stoppers is eliminated. The precision in determining the starting point in the initialization procedure is thus improved.

Electric actuator system

A motor stopping circuit is activated when a motor control circuit is stopped by a reset signal outputted from a reset circuit. This maintains an overrun angle small. As a result, a difference between a rotation angles measured when the motor control circuit is turned off and measured when the motor control circuit is turned on are small. Therefore, frequent origin setting operation is not required. This reduces sizes and manufacturing costs of a stopper and an actuator.

Growing community of inventors

Nagoya, Japan

Takashi Takata