Mitsubishi Jidosha Kogyo Kabushiki Kaisha

Tadakuni Takeda

Joji Matsubara

Katsunori Ueda

Jun Aoki

Kazuyoshi Nakane

Masayuki Takagaki

When, in a coexistence region where stratified combustion by a spray-guide method (SG combustion) and stratified combustion by a wall-guide method (WG combustion) are both practicable, a change from the SG combustion to the WG combustion is carried out, an ECU obtains point b giving a set of a fuel injection timing and an ignition timing capable of achieving the same target torque as a target torque in the SG combustion before the change, by the WG combustion, and changes the fuel injection timing and ignition timing stepwise from point a within an SG region to point b within a WG region, jumping across a misfire region, and then continuously to point c giving an optimal set of a fuel injection timing and an ignition timing corresponding to an MBT.

In-cylinder injection type spark-ignition internal combustion engine

In a direct injection type engine, capable of switching an injection mode between a compression stroke injection mode for injecting fuel mainly during a compression stroke and an intake stroke injection mode for injecting fuel mainly during an intake stroke; a fuel injection starting timing in the intake stroke is corrected to a retard side as the temperature relating to an internal combustion engine, detected as a parameter representing the tendency of fuel to adhere to the inside of the internal combustion engine, becomes lower. If a required fuel injection volume cannot be injected during the intake stroke injection mode in the corrected fuel injection timing, a timing for injecting remaining fuel to satisfy the required fuel injection volume during a compression stroke following the intake stroke in one combustion cycle is determined. The injection of the fuel is controlled according to the corrected fuel injection timing.

Growing community of inventors

Anjo, Japan

Tadakuni Takeda