Hitachi Energy Ltd

Hitachi Energy Switzerland Ag

Suresh Maturu

Obbalareddi Demudu Naidu

Neethu George

Od Naidu

Sachin Srivastava

Preetham Venkat Yalla

Vedanta Pradhan

Arulselvan G

Fault location determination in a power transmission system is described. Samples of voltage and current measured are obtained for each phase at a terminal. A first equivalent reactance value based on the samples of voltage and current is calculated. Further, based on the calculated equivalent reactance value a first fault location is determined.

Fault location determination in a power transmission system

Fault detection during a power swing in a power transmission system is described. Voltage and current measurements are obtained for each phase at a terminal of the power transmission system. Based on measurements obtained, a value of change in an impedance angle for each phase-to-ground loop and each phase-to-phase loop for each sample of the voltage and current values is calculated, where the value of change in the impedance angle is a difference between impedance angles of two samples separated by a predetermined interval. The average values for change in impedance angle based on a predetermined number of values of change in the impedance angle for each phase-to-ground loop and each phase-to-phase loop is calculated. The average values are compared with a threshold range of change in impedance angle. Based on the comparison, a fault in one or more of the phase-to-ground loops or phase-to-phase loops is detected and classified.

Fault detection in a power transmission system

Examples of operating an Intelligent Electronic Device (IED) during power swings, are described. In an example, voltage measurements for a phase is received and sampled. Root mean square (RMS) values of the voltage samples is calculated based on the voltage measurements. Delta quantities for each phase are calculated based on the RMS values. Each of the RMS values and delta quantities are associated with respective sampling instants. In response to a delta quantity being greater than a predefined threshold, a peak delta quantity is detected. A time interval between a sampling instant associated with the peak delta quantity and a sampling instant associated with a first delta quantity is determined. Based on a comparison of the time interval with a threshold time, a disturbance condition may be detected as a power swing and consequently, fault detection at the IED may be blocked.

Intelligent electronic device operation during power swing

Growing community of inventors

Andhra Pradesh, India

Suresh Maturu