Jfe Steel Corporation

Sumio Kaiho

Kazuhiko Yamazaki

Noriaki Moriyasu

Takeshi Yokota

Keisuke Nakazono

Shunsuke Toyoda

Yukio Kimura

Masataka Yoshino

Yukihiro Matsubara

Ayako Ta

Nobukazu Kitagawa

Saiichi Murata

A high-strength hot rolled steel sheet and a method for manufacturing the high-strength hot rolled steel sheet are disclosed. The high-strength hot rolled steel sheet includes a specific chemical composition, and a steel structure in which a lower bainite phase and/or a tempered martensite phase at 90% or more in terms of a total area fraction is contained as a dominant phase, an average grain size of the dominant phase is 10.0 μm or less, and an amount of Fe in Fe-based precipitates is 0.70% or less in mass %, in which an arithmetic average roughness (Ra) of a surface is 2.50 μm or less, and a tensile strength TS is 1180 MPa or more.

High-strength hot rolled steel sheet and method for manufacturing same

There are provided a high-strength hot-rolled steel sheet having a tensile strength of 980 MPa or more and a production method therefor. The high-strength hot-rolled steel sheet has a predetermined component composition and a microstructure containing 75.0% or more by area and less than 97.0% by area of a primary phase composed of an upper bainite phase, the primary phase having an average grain size of 12.0 &#x3bc;m or less, and more than 3.0% by area and 25.0% or less by area of a secondary phase that is a structure composed of one or two of a lower bainite phase and/or a tempered martensite phase, and a martensite phase, in which the number density of grains of the secondary phase having an equivalent circular diameter of 0.5 &#x3bc;m or more is 150,000 grains/mmor less, and the steel sheet has an arithmetic mean surface roughness of 2.00 &#x3bc;m or less.

High-strength hot-rolled steel sheet and method for producing the same

Provided is a material for a cold-rolled stainless steel sheet having a chemical composition containing, by mass %, C: 0.01% to 0.05%, Si: 0.02% to 0.75%, Mn: 0.1% to 1.0%, P: 0.04% or less, S: 0.01% or less, Cr: 16.0% to 18.0%, Al: 0.001% to 0.10%, N: 0.01% to 0.06% and the balance being Fe and inevitable impurities. The material has a metallographic structure including a martensite phase having an area ratio of 5% to 50% and the balance being a ferrite phase. A ferrite phase in portions extending from surface layers of front and back surfaces of a steel sheet has an average grain diameter of 20 &#x3bc;m or more and 50 &#x3bc;m or less, and a ferrite phase in a central portion of the sheet includes an unrecrystallized ferrite phase.

Material for cold-rolled stainless steel sheet

Growing community of inventors

Chiba, Japan

Sumio Kaiho