Qume Corporation

Mechatron Systems, Inc.

Oume Corporation

501 Qume Corporation

Suhdok D Moon

John W Jamieson

Frank W Lin

Sen L Lee

Marshall H Trackman

Max I Anzai

Tri S Van

To enable a microprocessor to operate within its bandwidth limitations while controlling a serial printer, means are provided for adjusting the microprocessor system clock rate when the printer is in its rate mode. In particular, the output of a counter clocked by the pulses from an encoder representing the velocity of a member is controlled; the output of the counter being selectively applied to the microprocessor in accordance with the velocity of the member being controlled.

Technique for compensation for bandwidth limitations of microprocessor

A speed normalization circuit for eliminating the need to fine tune a servomechanism, such as a daisy wheel printer, after manufacture, for example, in order to compensate for speed variations caused by tolerance variations throughout the manufacturing process and evidenced by variations in the actual print wheel speed and the actual carriage speed, is disclosed. In operation, when a restore sequence is called for (power up, remote restore, cover open/resume, check/resume), the carriage is restored to the leftmost home position and is then stepped three times by an identical amount (twelve increments, 1/120 of an inch per increment). The average value of the actual carriage speed for these three movements is determined and a compensation value is selected. If the carriage speed is too slow, the nominal speed value stored in a read only memory look-up table is incremented by a fixed value (i.e., plus one, two, or three units); if the speed is too fast, the nominal speed value is decremented by a fixed value (i.e., minus one, two, or three units). The compensation value is added to the nominal speed value during subsequent actual operation of the servomechanism. For the print wheel, there are two programmed movements upon restore, namely, one half rotation in each direction (one forward, one reverse) for a total of ninety-six increments per movement. The speed compensation value is calculated in the same manner. Other features are also disclosed.

Method and apparatus for normalizing the speed of an element

A printer having a print wheel rotatable on a carriage. The carriage is guided for movement parallel to a platen. The printer may print at either a fast speed for draft quality output, or a slower speed for highest quality output. The lesser quality of output produced at the fast speed is more than adequate for draft documents.

Daisywheel printer

A printer of the daisywheel type in which the existence of a carriage control signal and a printwheel control signal operate inhibiting apparatus for a control signal otherwise gated to a paper feed operator.

Growing community of inventors

Los Altos, CA, United States of America

Suhdok D Moon