Headway Technologies, Incorporated

Tdk Corporation

Stuart Kao

Chunping Luo

Jeiwei Chang

Daisuke Miyauchi

Takahiko Machita

Chaopeng Chen

Chao Chen

Min Li

Kochan Ju

Jei-Wei Chang

Using a beam of xenon ions together with a suitable mask, a stack is ion milled until a part of it, no more than about 0.1 microns thick, has been removed so that a pedestal having sidewalls, including a vertical section and a shortened taper portion, has been formed. This is followed by formation of conductive lead layers as needed. Using xenon as the sputtering gas enables the point at which milling is terminated to be more precisely controlled.

Method of using xenon ion beams to improve track width definition

Using a beam of xenon ions together with a suitable mask, a MTJ stack is ion milled until a part of it, no more than about 0.1 microns thick, has been removed so that a pedestal, having sidewalls comprising a vertical section that includes all of the free layer, has been formed. This is followed by formation of the longitudinal bias and conductive lead layers in the usual way. Using xenon as the sputtering gas enables the point at which milling is terminated to be more precisely controlled.

Process to manufacture magnetic tunnel junction read head

The series resistance of a CPP GMR stack can be reduced by shaping it into a small upper, on a somewhat larger, lower part. Because of the sub-micron dimensions involved, good alignment between these is normally difficult to achieve. The present invention discloses a self-alignment process based on first laying down a mask that will determine the shape of the top part. Ion beam etching is then initiated, the ion beam being initially applied from one side only at an angle to the surface normal. During etching, all material on the near side of the mask gets etched but, on the far side, only material that is outside the mask's shadow gets removed so, depending on the beam's angle, the size of the lower part is controlled and the upper part is precisely centrally aligned above it.

CPP head with parasitic shunting reduction

Using a beam of xenon ions together with a suitable mask, a GMR stack is ion milled until a part of it, no more than about 0.1 microns thick, has been removed so that a pedestal, having sidewalls comprising a vertical section that includes all of the free layer, has been formed. This is followed by formation of the dielectric and conductive lead layers in the usual way. Using xenon as the sputtering gas enables the point at which milling is terminated to be more precisely controlled.

Process to manufacture CPP GMR read head

Using a beam of xenon ions together with a suitable mask, a GMR stack is ion milled until a part of it, no more than about 0.1 microns thick, has been removed so that a pedestal, having sidewalls comprising a vertical section that includes all of the free layer, has been formed. This is followed by formation of the longitudinal bias and conductive lead layers in the usual way. Using xenon as the sputtering gas enables the point at which milling is terminated to be more precisely controlled.

Xenon ion beam to improve track width definition

As feature sizes approach 0.1 &#x3bc;m or smaller, reduction of line edge roughness (LER) becomes increasingly important. Significant reductions in edge roughness have been achieved by applying a second Ebeam exposure after the initial one that is used to define the pattern. After this second blanket exposure a longer heat treatment and a stronger development process than before are used. In addition to reducing edge roughness the disclosed treatment allows the CD to be reduced under tight control since the amount of CD reduction is proportional to the second Ebeam dosage.

Growing community of inventors

Fremont, CA, United States of America

Stuart Kao