Navatek, Ltd.

Steven C H Loui

Scott Yamashita

Mealani Parish

Gary Shimozono

Christopher Hart

Lorne Frederick Campbell

Eric Schiff

Jeff Kline

The disclosed watercraft hull has a flat pad keel whose width tapers towards the bow and its width at the transom is 15% to 25% of the hull's width at its chines. The hull is symmetric about its centerline, has a fine entry bow, a transom, and a pair of hard chines. Between the pad keel and the chines the hull has at least one pair of generally flat panels referred to herein as longitudinal steps having approximately 0 degrees of deadrize forming planing surfaces symmetrically located about the hull centerline. The hull also includes at least one pair of ultra high deadrize panels, outboard of and adjacent to the pad keel, located symmetrically about the hull centerline, and extending therefrom to the flat planing panels above them. The ultra high deadrize panels have a minimum average deadrize of approximately 50 degrees measured along their length. Additional flat planing surface structures having approximately 0&#xb0; deadrize may be installed longitudinally on the hull between the pad keel and the hard chine such that the vertical offset between any two planing surfaces along the hull's stagnation line does not exceed approximately six inches. High deadrize panels or fillet panels with deadrize angles of between about 0.20 and 35 degrees may be included in the hull outboard of and adjacent to the ultra high deadrize panels and located symmetrically about the hull centerline. The fillet panels are tapered into wedge shapes at their forward ends to blend into the adjacent ultra high deadrize and flat planing panels.

Planing hull for rough seas

An inflatable watercraft is provided with multiple reinforced panels that are configured to form a center hull having a V-form. The center hull supports a floor that is coupled to a U-form collar. The panels also form a pair of outer side hulls respectively disposed on opposite sides of the center hull and which define a tunnel between the center hull and each of the outer side hulls.

Inflatable watercraft with reinforced panels

An engine-powered watercraft includes three parallel hulls, namely a center hull with two or more transverse steps, and two smaller outer hulls or amas on either side of the center hull that are configured to form two vent ducts on either side of the center hull, disposed between the center hull sides and the amas. The amas, steps and vent ducts are disposed along the length of the watercraft and are configured to enable high speed capability and to facilitate pressurization of the vent ducts. The pressurized vent duct maximizes ventilation of the running bottom of the watercraft so as to improve efficiency and to reduce drag thereon. The pressurized vent duct creates an area of lift at the widest, aft-most points of the running bottom, which thereby results in improving the transverse and longitudinal stability of the watercraft and in reducing the trim for better seakeeping.

Watercraft with hull ventilation

Growing community of inventors

Honolulu, HI, United States of America

Steven C H Loui