Teledex Corporation

Spencer L Hermanson

Mario E Jauregui

Ronald S Lesniak

Maxim Bakaleynik

Elaine C He

Gloria I Seamons

Temujin Kuechle

Elena Pimkina

Sean Horita

William G Marks

Tung Hang Song

Charles R Jackson

Crescendo telephone ringers and methods of providing a crescendo telephone ring signal. The crescendo telephone ringer provides a gradual increase in audible ringing volume as a sequence of incoming electrical ring signals is detected. According to one embodiment, upon receipt of an incoming call, a first audible ring signal corresponding to a first detected electrical ring signal is set to a minimum volume. Subsequent audible ring signals corresponding to subsequent detected electrical ring signals are set to increasing volume levels, and finally to a maximum ringer volume.

Crescendo telephone ringer

Telephone

An electronic programmer for the auto-dial functions of a telephone comprises an apparatus which electrically connects the rows and columns lines on the keyboard of a telephone so as to mimic the pressing the buttons on the telephone keypad.

Electronic programmer for telephones with auto-dial

A circuit for notifying a PBX that a data port in a telephone connected to the PBX is about to be used. The circuit comprises a current sensor for generating a signal that indicates a modem is drawing current through the data port. A large resistor limits the current being drawn through the data port to a level that does not indicate an off-hook condition to either the PBX or the modem. In response to the signal generated by the current sensor, a separate telephone circuit provides an off-hook condition that draws a first dial tone from the PBX. A microprocessor in the circuit generates a signal that causes a dialer in the telephone circuit to dial a number that notifies the PBX that the modem is attempting to access the PBX through the data port. After the PBX is notified of the imminent data port usage, it presents a second dial tone on line two which is the dial tone for an outside line. The microprocessor then activates a thyristor which electrically bypasses the resistor and allows sufficient current to be drawn by the modem to maintain the off-hook condition.

Method and apparatus for detecting data port usage

A line-powered circuit for connecting a telephone line to a telephone voice circuit comprised of a digital part and an analog part. The digital part is a logic circuit for generating a line connect signal that indicates a telephone line should be connected to the voice circuit. The power for operating the logic circuit is provided by the line voltage associated with the tip and ring leads of the telephone line. The analog part comprises a first switch means for connecting the voice circuit to the tip lead in response to the line connect signal, and a second switch means for connecting the voice circuit to a ring lead in response to the line connect signal.

Low power line selection circuit for a telephone

A message waiting circuit comprised of a pair of electrical leads which carry a message waiting signal, a capacitor for storing electrical energy extracted from the message waiting signal, a transistor for allowing the capacitor to charge when the message waiting signal is within a predetermined range; a Darlington transistor for causing the capacitor to discharge; and a light emitting diode (LED) which emits light when the capacitor discharges. The flashing LED indicates that a message is waiting for a user of the telephone set associated with the message waiting circuit. Approximately ten to twenty-five message waiting circuits and associated telephone sets can be connected to a single telephone line.

Growing community of inventors

San Jose, CA, United States of America

Spencer L Hermanson