Nhk Spring Co., Ltd.

Sosuke Kurebayashi

Naoki Iwamoto

Yohei Mitsumori

A lift mechanism of a die set apparatus includes a guide pin, a linear motion guide member, a first washer, a second washer, a first coil spring, and a second coil spring. A first positioning portion and a second positioning portion control a first end turn portion and a second end turn portion from moving in a radial direction of the guide pin in a state where a first gap is formed between the first coil spring and the guide pin. A third positioning portion and a fourth positioning portion control a third end turn portion and a fourth end turn portion from moving in the radial direction of the guide pin in a state where a second gap is formed between the second coil spring and the guide pin.

Die set apparatus

A load beam includes a pair of flange bending parts including first bending parts, and a second bending part extending in a width direction. A first cross-section part extends in the width direction of the load beam passing through welding parts. The first cross-section part is warped up toward the flange parts. A second cross-section part extends in the width direction passing through a different position from that of the welding parts. The second cross-section part has a lesser height difference as compared to the first cross-section part. A die is used when bending the second bending part. The die includes a first relief part including a first inclined surface and a second relief part including a second inclined surface in both sides of the supporting surface.

Growing community of inventors

Yokohama, Japan

Sosuke Kurebayashi