Marelli Cabin Comfort Japan Corporation

Shinya Sato

Naohisa Kamiyama

Makoto Murakami

Ikuo Kataoka

Tetsuzo Nishimura

Takaaki Ikari

Toshihiko Kubo

The casting mold is provided with: the molding wall portion forming the internal space; and the filling ports that open to the molding wall portion and that allow the molten metal to flow into the internal space. In this configuration the channel center lines of the filling ports intersect the surface of the heater at the non-perpendicular contact angle.

Casting mold and manufacturing method of cast part

The casting mold is provided with: the molding wall portion forming the internal space; the supporting portion supports the heater to the molding wall portion; and the filling port allows the molten metal to flow into the internal space. The heater has: the end portion (the fixed portion) supported by supporting portion; and the extending portion extended from the end portion. The internal space has: the supporting region accommodating the end portion; and the extending region accommodating the extending portion. The filling ports respectively open to the portions of the molding wall portion facing the supporting regions.

The heater (structure) has the gaps facing the molding wall portion of the casting mold. The casting mold is provided with: the molding wall portion forming the internal space; and the gap-portion filling ports (filling ports) that open to portions of the molding wall portion facing the gaps of the heater and that allow the molten metal to flow into the internal space.

Growing community of inventors

Ueda, Japan

Shinya Sato