Toyota Jidosha Kabushiki Kaisha

Shinya Fujimura

Yuji Hattori

Takaho Kawakami

Takahiro Yokokawa

Hiroyuki Shioiri

Hiroaki Kimura

A sheave positioning device is provided. A valve element is arranged on a flow path to close the flow path when pushed in a direction against a pressure from hydraulic chambers, and a valve closing mechanism is also arranged on the flow path to generate a thrust force for pushing the valve element in the direction against a pressure from the hydraulic chambers. The valve closing mechanism is adapted to generate the thrust force, which is larger than a load to be applied to the valve element to push the valve element in a direction to open the valve element in case a predetermined speed change ratio is being set, but smaller than a load to be applied to the valve element to push the valve element in a direction to open the valve element in case the pressure in the hydraulic chambers is raised to the maximum pressure.

Sheave positioning device

If it is determined that a malfunction has occurred in an electrical hydraulic pump and the hydraulic fluid is not supplied to a high hydraulic pressure supplied portion from the electrical hydraulic pump, the hydraulic fluid is supplied to the high hydraulic pressure supplied portion from a mechanical hydraulic pump that usually supplies the hydraulic fluid to a low hydraulic pressure supplied portion. In this case, the hydraulic pressure that is generated by the mechanical hydraulic pump is increased by increasing the output from the engine that drives the mechanical hydraulic pump.

Hydraulic control apparatus and hydraulic control method

A shift controller for an automatic transmission mechanism is configured such that when the engine is in a driven state in which the engine is driven by a travel inertia force or the like and an accumulated pressure amount of the accumulator is equal to or less than a predetermined threshold, the excessive engine brake force, which is generated due to the accumulation of at least a portion of the hydraulic pressure generated from the mechanical hydraulic pump in the accumulator, is inhibited or reduced by conducting upshifting that relatively decreases the gear ratio of the automatic transmission mechanism. Therefore, the generation of the excessive engine brake force can be inhibited or reduced even when the engine is in the driven state and pressure accumulation is performed.

Shift controller and shift control method for automatic transmission mechanism

A flow control valve is provided in a primary pulley that is a rotor, and includes a first port; a second port; a working fluid channel formed between the first port and the second port and through which working oil passes; a check valve that is formed in the working fluid channel and is opened toward a first-port-side channel from a second-port-side channel of the working fluid channel; and a valve-opening control section (a guide member, a spool, a cylinder, and a drive pressure chamber) that is arranged at the check valve at the side of the second port, that forcibly opens the check valve when discharging the working fluid from the first port to the second port, and increases a channel resistance of the second-port-side channel as an opening amount of the check valve is small. The flow control valve can prevent over-discharge of the working fluid at the beginning of opening the valve.

Growing community of inventors

Susono, Japan

Shinya Fujimura