Z Ama Japan Co., Ltd.

Iida Denki Kogyo Co., Ltd.

Ryouhei Yamashita

Akira Yamazaki

Takumi Nonaka

Hideki Watanabe

Tamotsu Saitou

A speed reduction method for a hand-carried engine-driven working machine is provided in which a speed reduction of an engine can be attained reliably and safely by preventing the occurrence of lean come-down phenomenon in such a state that the engine is operating in a practical revolution speed range. An acceleration is calculated based on a change in revolution speed, and when the acceleration becomes smaller than a predetermined threshold, an ignition timing is retarded by a desired amount based on a determination that the engine is being decelerated, and further, a fuel flow rate is also increased, whereby the decelerated state of the engine is maintained without fail, so that the occurrence of lean come-down phenomenon is prevented in the process of reducing the revolution speed of the engine.

Speed reduction method for hand-carried engine-driven working machine

The opening of a solenoid valve is automatically adjusted after an engine is started and before actual work is performed for an appropriate air-fuel ratio, whereby it is possible to attain a good and stable driving of the engine without any delay even for an abrupt change in load. After the engine is started, when a rotation speed enters a 'fuel flow rate adjusting rotation speed range' in which a definite load is applied to the engine in a working rotation speed range of the engine in which a throttle valve is opened to a definite opening, a detected rotation speed is fed back to a target rotation speed, and the opening of the solenoid valve is controlled to adjust a fuel flow rate, so that the combustion state in the engine is optimized at the valve opening so determined.

Fuel control method for hand-carried engine-driven working machine

A method for making an optimum combustion during engine operating time changes a fuel flow rate of the solenoid valve on the basis of engine rotational speed feedback control during engine idling time at low engine rotational speed and low electric power consumption. During engine idling time of an engine are carried out a rotational speed detecting process, an idle rotation adjusting process of making a rotational speed detected by the rotational speed detecting process equal to an initial value of rotational speed by controlling an ignition timing while comparing the detected rotational speed with the initial value of rotational speed as target value, and a valve opening correction process according to idle ignition timing change (I.I.T.C.) obtained by the idle rotation adjusting process. The valve opening is set to an adjusted valve opening (A.V.O.) plus a correction valve opening (C.V.O.) by the valve opening correction process.

Growing community of inventors

Tokyo, Japan

Ryouhei Yamashita