Lutron Electronics Company, Inc.

Lutron Technology Company LLC

Russell Lawrence MacAdam

Mark Stephen Taipale

John Francis Waymouth

Robert Thomas Nachtrieb

Farheen Khan

Mark Alan Hartfield

Renzo Corrado DeMeo

Robert William Lenig

Joshua W Thaler

Michael Sizemore

Joel S Spira

Venkatesh Chitta

Russell Weightman

Scott Curtis Miller

Joseph T Parent

Ian Rowbottom

Noel Mayo

Matthew R Zartman

Adam T Lansing

Robert A Reiss

Matthew Robert Blakeley

Johnathan Paul Ross

Jason C Killo

David G Luchaco

Andrew Ryan Offenbacher

Simo P Hakkarainen

Jecko Arakkal

Kolawole A Otitoju

Oliver K Mihm

Kenneth D Walma, Jr

A load control device may control power delivered to an electrical load from an AC power source. The load control device may include a controllably conductive device adapted to be coupled in series electrical connection between the AC power source and the electrical load, a zero-cross detect circuit configured to generate a zero-cross signal representative of the zero-crossings of an AC voltage. The zero-cross signal may be characterized by pulses occurring in time with the zero-crossings of the AC voltage. The load control device may include a control circuit operatively coupled to the controllably conductive device and the zero cross detect circuit. The control circuit may be configured to identify a rising-edge time and a falling-edge time of one of the pulses of the zero-cross signal, and may control a conductive state of the controllably conductive device based on the rising-edge time and the falling-edge time of the pulse.

Controlling a controllably conductive device based on zero-crossing detection

A load control device for controlling power delivered from an AC power source to an electrical load may comprise a thyristor, a gate current path, and a control circuit. The control circuit may be configured to control the gate current path to conduct a pulse of gate current through a gate terminal of the thyristor to render the thyristor conductive at a firing time during a half-cycle of the AC power source. The control circuit may operate in a first gate drive mode in which the control circuit renders the gate current path non-conductive after a pulse time period from the firing time. The control circuit may operate in a second gate drive mode in which the control circuit maintains the gate current path conductive after the pulse time period during the half-cycle.

Load control device for high-efficiency loads

A load control device for controlling the amount of power delivered to an electrical load may include a rectifier circuit configured to receive a phase-control voltage and produce a rectified voltage. A power converter may be configured to receive the rectified voltage at an input and generate a bus voltage. An input capacitor may be coupled across the input of the power converter. The input capacitor may be adapted to charge when the magnitude of the phase control voltage is approximately zero volts. The power converter may be configured to operate in a boost mode, such that the magnitude of the bus voltage is greater than a peak magnitude of the input voltage. The power converter may be configured to operate in a buck mode to charge the input capacitor from the bus voltage when the magnitude of the phase-control voltage is approximately zero volts.

Charging an input capacitor of a load control device

An electronic dimming ballast or light emitting diode (LED) driver for driving a gas discharge lamp or LED lamp may be operable to control the lamp to avoid flickering and flashing of the lamp during low temperature or low mercury conditions. Such a ballast or driver may include a control circuit that is operable to adjust the intensity of the lamp. Adjusting the intensity of the lamp may include decreasing the intensity of the lamp. The control circuit may be operable to stop adjustment of the intensity of the lamp if a magnitude of the lamp voltage across the lamp is greater than an upper threshold, and subsequently begin to adjust the intensity of the lamp when the lamp voltage across the lamp is less than a lower threshold. Subsequently beginning to adjust the intensity of the lamp may include subsequently decreasing the intensity of the lamp.

Methods and systems for controlling an electrical load

Growing community of inventors

Coopersburg, PA, United States of America

Russell Lawrence MacAdam