Varta Batterie Aktiengesellschaft

Rudolf Eckardt

Dieter Bechtold

Klaus Salamon

Wolfgang Kappus

Herbert Zweigardt

Karl-Friedrich Gutlich

The cell poles of an electric battery, which have already been cast on a fully assembled plate group which is fixed in proper position for mounting in a holding box, are provided with a plastic coating using a dual injection mold which matches the predetermined distance between the poles. After the two mold halves are closed over the poles, a plastic melt is injected into cavities corresponding to the poles, which plastic is at the same time prevented from escaping from the mold by a gasket at the base of each cell pole, and a movable slide at the forwardmost end of each cell pole.

Process and apparatus for the plastic injection coating of cell poles of

A cover which is to be sealed tightly to the corresponding plastic container of a battery cell by means of radiant heating is provided with a series of molded knobs along the lower side of its edge, which knobs serve as spacers between the cover and the edge of the container during the heat-up phase so that the surfaces to be bonded are exposed to the radiant heat without obstruction. The softened knobs are plasticized and bonded when the container and the cover are subsequently pressed together.

Cover for a battery cell

In an electric storage battery having plate electrodes, the capacity and useful life is improved through uniform distribution of concentration and temperature of the electrolyte by means of electrolyte circulation. A synthetic plastic plate positioned between the plate electrodes and the housing wall of the storage battery contains a plurality of vertically extending transport tubes which are open at their upper and lower ends. The bottom portions of the transport tubes, which are immersed in the electrolyte, are connected to compressed air ducts. The compressed air is mixed with the electrolyte present in the transport tube in such a manner that the electrolyte-air mixture present therein is lifted, due to its lower specific gravity, by the electrolyte which surrounds the transport tube. The electrolyte leaving the transport tube produces continuous circulation within the storage battery, and this ensures permanent exchange of the electrolyte present between the plate electrodes.

Electric storage battery with gas driven electrolyte movement

A lead storage battery terminal is constructed of copper or aluminum sleeving, which may be clad with lead, and is sealed into the terminal aperture in the battery lid. The bottom of the sleeve is closed and permanently attached to the lead pole bridge.

Growing community of inventors

Steinbach, Germany

Rudolf Eckardt