Apple Inc.

Ronald William Dimpflmaier

Matthias Sauer

Rastislav Vazny

Lydi Smaini

Tarik Tabet

Nicholas W Lum

Joonhoi Hur

Bernd W Adler

Christian W Mucke

William Jean Noellert

Syed Aon Mujtaba

Awais M Hussain

Moustafa M Elsayed

Alexander Sayenko

Louie J Sanguinetti

Anatoliy Sergey Ioffe

Venkateswara Rao Manepalli

Farouk Belghoul

Fucheng Wang

Jesse Yu

Rafael L Rivera-Barreto

Cesar Perez

Daniel R Borges

Paul V Flynn

Joseph Hakim

Tushar Ramanlal Shah

Daniel Kong

Robert S Sorensen

Anatoliy Sergey Toffe

Louis Joseph Sanguinetti

Nicholas Wesley Lum

A user equipment (UE) device may communicate according to a new device category satisfying specified QoS (quality of service) requirements while also satisfying specified link budget requirements, and/or additional optimization requirements. The UE device may communicate with a cellular base station according to a first mode of operation associated with the new device category, and may switch to communicating with the cellular base station according to a second mode of operation associated with a second (pre-existing) device category in response to the link budget requirements exceeding a specified value and the quality of service requirements not being sensitive. The UE device may also switch to communicating with the cellular base station according to a third mode of operation associated with a third (pre-existing) device type in response to the link budget requirement not exceeding the specified value, or the QoS requirements being sensitive and a downlink throughput requirement exceeding a specified throughput value.

Device category in 3GPP communications

An electronic device may transmit a communication request to a base station having an indication of a number of its receive branches and an indication of whether the communication request is designated as an urgent service fulfillment. The base station may delay a denial of the communication request until receiving the indication of whether the communication request is designated as using the urgent service fulfillment to reduce a likelihood of prematurely rejecting the communication request. The base station may also handover the communication request to a base station that supports the urgent service fulfillment. The base station may also be barred from transferring the user equipment to a frequency layer preferred by the base station when the communication request of the user equipment is designated as an urgent service fulfillment.

Systems and methods for emergency service access by reduced capability radio frequency devices

A portable electronic device includes a baseband integrated circuit configured to generate communication data and control signals. The portable electronic device also includes an optical path configured to be coupled to the baseband integrated circuit to transmit the data signals from the baseband integrated circuit. The portable electronic device additionally includes a radiohead configured to be coupled to the optical path to receive the data signals transmitted along the optical path from the baseband integrated circuit.

RF radiohead with optical interconnection to baseband processor

An electronic device discussed herein may include radio frequency communication circuitry for communication on a radio frequency network according to a communication configuration, a processor, and memory. The memory may store instructions that, when executed by the processor, cause the electronic device to perform operations including receiving, a first muting configuration indicating when the radio frequency communication circuitry is to communicate using a first type of communication on a first frequency band and when the radio frequency communication circuitry is to communicate using a second type of communication on a second frequency band, where the first frequency band may overlap with the second frequency band. The memory may store instructions that, when executed by the processor, cause the electronic device to perform operations including transmitting or receiving a data packet using the radio frequency communication circuitry according to the communication configuration.

Systems and methods for cooperative communication using interfering signals

Systems, methods, and devices for operating in either frequency division duplexing (FDD) or time division duplexing (TDD) for wireless communications using the same electrical balance duplexer (EBD) circuitry in a transceiver device are provided. A series of switches may selectively couple components of the EBD, such as a low noise amplifier (LNA), a power amplifier (PA), and balancing impedance, to ground based on selected operation mode (e.g., FDD or TDD) while reducing insertion loss of the receiver (RX) and transmitter (TX) signals. Tuned matching network blocks for the LNA and PA may be used in addition to the series of switches to provide impedance matching for additional reduction of insertion loss.

Reconfigurable electrical balance duplexer (EBD) supporting frequency division duplex (FDD) and time division duplex (TDD)

This disclosure relates to techniques for supporting narrowband device-to-device wireless communication, including possible techniques for performing discovery in an off grid radio system. A wireless device may obtain synchronization with a peer-to-peer communication group. The wireless device may determine the location of the wireless device within the peer-to-peer communication group based at least in part on signal strength of a synchronization signal used to obtain the synchronization. The wireless device may perform peer-to-peer discovery in the peer-to-peer communication group, such that time and frequency resources used by the wireless device to perform the peer-to-peer discovery are determined based at least in part on the location of the first wireless device within the peer-to-peer communication group.

Discovery procedure for off grid radio service

Systems, methods, and devices for reducing insertion loss and/or swapping transmitter (TX) and receiver (RX) frequencies in an electrical balance duplexer (EBD) used in a transceiver device for frequency division duplexing (FDD) applications are provided. Feed-forward receiver path from the antenna to a low noise amplifier (LNA) and a feed-forward path from the antenna to a power amplifier (PA) of the EBD may be used for reducing insertion loss of the RX and TX signals. In some embodiments, switches may be used to selectively alter operational modes for varied levels of isolation and/or swapping of TX and RX frequencies.

Reconfigurable feed-forward for electrical balance duplexers (EBD)

This disclosure relates to techniques for supporting narrowband device-to-device wireless communication, including possible techniques for performing control and data communications between wireless devices that have performed discovery. A first device may transmit first control information to a second wireless device. The first control information may indicate a buffer status of the first wireless device. The first device may receive second control information from the second wireless device. The second control information may include an acknowledgement indication for the first control information. The first device may transmit a data communication to the second wireless device based at least in part on the first control information and the second control information.

Control and shared channels in device-to-device communication

The representative embodiments discussed in the present disclosure relate to techniques in which isolation between transmission signals and received signals in a transceiver may be maintained during downlink carrier aggregation. More specifically, in some embodiments, the transceiver may be implemented to include an electrical balance duplexer that isolates a signal component of a signal transmitted via the transceiver from a receiver signal path of the transceiver. The transceiver may also include analog interference cancellation circuitry implemented to isolate a noise component of the signal transmitted via the transceiver from the receiver signal path (e.g., from one or more downlink receiver channels). As such, the transceiver may operate using inter-band, non-contiguous downlink carrier aggregation, intra-band, non-contiguous downlink carrier aggregation, intra-band, contiguous carrier aggregation, and/or the like.

Downlink receiver channel isolation

Growing community of inventors

Los Gatos, CA, United States of America

Ronald William Dimpflmaier