General Electric Company

Roman Herschitz

Alexander Bogorad

Paul V Barcomb

Robert N Harhigh

John G Leung

John G Munro, Iii

Stephen H Chu

Scott T Demarest

An RF-transparent blanket provides thermal protection against solar and laser radiation. The blanket includes an outer layer of a transparent Kapton dielectric sheet with an outer surface coated with electrically conductive transparent indium-tin oxide to aid in suppressing electrostatic discharge. A second layer includes a transparent Kapton dielectric sheet with a coating of white silicone paint on the surface facing the first sheet. The outermost Kapton sheet protects the paint from long-term damage due to charged particle fluence and ultraviolet radiation. Further sheets of uncoated transparent Kapton, which may be embossed, are interposed between the second layer and a surface upon which an antenna is mounted to provide thermal insulation.

RF-transparent spacecraft thermal control barrier

A method for welding together the broad faces of two conductive sheets increases the reliability and consistency from weld to weld. The sheets are accessible from only one side for parallel electrical resistance welding. The electrical resistance between one sheet and the other is measured and taken as an indication of the amount of dirt or corrosion in the interface between the sheets. The measured resistance is compared with a predetermined standard. If the resistance exceeds the standard, the faces are cleaned. If the resistance is below the standard, electrical power is applied to fuse the sheets together.

Preweld test method

A method for welding two pieces includes juxtaposing the pieces and monitoring the temperature of the region to be welded. Energy is applied at a time rate sufficient to raise the temperature of the region to be welded at a rate exceeding a predetermined value. Once a predetermined temperature is reached, that temperature is held for a predetermined time. The rate of rise of temperature is 70% of the final or predetermined temperature in 20% of the predetermined time. After the weld is made, the rate of fall of the temperature exceeds a predetermined value. Quenching may be used to achieve the desired rate of fall.

Constant temperature welding method

Growing community of inventors

Plainsboro, NJ, United States of America

Roman Herschitz