Joby Aero, Inc.

Robert Thodal

Edward Stilson

Joachim L Grenestedt

JoeBen Bevirt

Drew Boggio

Ernest Matthew Villanueva

Austin Lawrence Newman

Gregor Veble Mikić

Michael Patrick Tucker

Baixi Pei

Percy Pei

Christopher Cochran

Matthew Clyde Cusimano

Ahsan Mehmood

Gregor Veble Mikic

Edward Thomas Sweet

Jordin Gischler

Florian Jule

An extension linkage for a wing flap can include at least one arm that includes two elements connected by a joint. The linkage can include an actuation mechanism, additional arms and/or each arm can include more than two elements, tie rods and/or cross pieces connecting two or more arms, and any other suitable components. The linkage functions to translate and rotate a body attached to one end of the arm relative to a primary structure attached to a second end of the arm. The linkage resides entirely within a space defined by the upper skin and the lower skin of the wing rearward of the mounting when in a retracted configuration.

Three-dimensional extension linkage for aircraft

A rotor assembly deployment mechanism configured to deploy a rotor assembly of a vertical take-off and landing aircraft from a horizontal, forward thrust, position to a vertical, hover, position. The rotor assembly deployment mechanism is configured to deploy an electric motor and propeller together. The deployment mechanism provides significant stiffness and strength with the use of torsion box constructions. The deployment mechanism may utilize bar linkages wherein the primary linkage pivot is of a large diameter relative to the span of the pivot in order to provide significant stiffness. The deployment mechanism may utilize rotary actuators to drive the deployment and stowing of the rotor assembly.

Rotor assembly deployment mechanism and aircraft using same

An aircraft includes a battery pack mounted inside the aircraft, a vent coupled between the battery pack and a surface of the aircraft to at least partly define a vent path between the battery pack and the surface of the aircraft, and a burst membrane located in the vent path. The vent may be coupled to a rear upper portion of a wing or to an outboard side of a nacelle. The aircraft may also include a flexible coupling between the vent and the surface of the aircraft. The aircraft may also include a fairing over a vent outlet to provide a smooth surface for the vent outlet. The battery pack may include battery modules and an enclosure, the battery modules and the enclosure defining paths along which discharge from a thermal event can flow towards the vent.

Aircraft energy storage venting system

An aircraft includes a battery pack, an internal support structure to support the battery pack in the aircraft, a first bracket rigidly coupling the battery pack to the support structure, and a second bracket rotationally coupling the battery pack to the support structure. The first and second brackets may be located on opposite sides of the battery pack. The internal support structure may be located in a wing of the aircraft and the first and second brackets may be aligned in a fore-aft direction of the aircraft. The internal support structure may be located in a nacelle of the aircraft and the first and second brackets may be aligned along a transverse direction of the aircraft. The second bracket may include two hangers to support a mass of the battery pack in tension.

Aircraft energy storage mounting system

The 3D extension linkagecan include at least one arm that includes two elements connected by a joint. The linkage can include an actuation mechanism, additional arms and/or each arm can include more than two elements, tie rods and/or cross pieces connecting two or more arms, and any other suitable components. The linkagefunctions to translate and rotate a body attached to one end of the arm relative to a primary structure attached to a second end of the arm.

Three-dimensional extension linkage

Growing community of inventors

Santa Cruz, CA, United States of America

Robert Thodal