Deere & Company

Robert Matthew Bares

Jeffrey Robert Fox

Michael Lee Pearson

Timothy Arthur Deutsch

Jesse D Haecker

William Edward McCoy

Cotton harvester frame structure includes main structural members elevated to approximately cab floor level and extending horizontally rearwardly in a planar fashion over the engine compartment and the rear axle. The structural members attach to the central portion of the rear axle to provide added clearance for larger wheels and tires. The single elevated plane of the main frame structure provides simplified attachment of a power module including a transversely mounted engine. Access areas under the main structural members are of sufficient minimum width and height to allow an operator or an assembler to stand fairly erect while accessing most areas of the power module and a harvester fan.

Cotton harvester chassis configuration

An electronic controller with a sensed ground speed input calculates appropriate cotton harvester row unit speed based on harvester ground speed and a preset ground speed versus a unit speed curve. The controller includes an automatic or manual ratio adjustment input. The ratio adjustment input allows the unit speed to be increased or decreased from the preset speed. The controller reads row unit speed via unit speed sensors and sends a signal to the unit speed actuator or electronic drive control (EDC) on a hydro, variable sheave, or other variable drive device to adjust unit speed to the calculated value. A detector or field vision device such as a camera responsive to cotton on the plants provides a signal to the automatic ratio adjustment input to change the ratio for increased productivity and reduced machine wear.

Cotton harvester row unit speed synchronization control

A chassis-mounted round baler particularly useful with an on-board cotton module building system includes a bale release gate frame section connected to a forward frame section by a four bar linkage to define a gate path that allows the folding of the baler into both field transport and shipping configurations while maintaining desirable operating, transport and shipping heights. The gate linkage incorporates a self latching feature wherein a small vertical movement of the gate as the gate cylinders are operated releases a gate latch member from a forward frame member during gate opening and reengages the gate latch with the forward frame member during closing. The gate interacts with the bale handler to provide a stop for the baler gate when the baler gate is placed into a cradle on the handler.

Baler gate linkage and latch structure

A hood receives a stream of material including a mix of cotton, air and debris from an air delivery system on a cotton harvester. A forward deflector directs the mixture towards the rear of an accumulator. The deflected mixture passes under finger grates which retains cotton but allows some of the air and light trash to pass through out of the stream. A curved rear deflector forces the remaining mix downwardly towards the accumulator and prevents build-up on receptacle walls. Air and light debris change direction abruptly at the bottom of the rear deflector and exit through an inlet area and upwardly directed path at the back of the deflector. The momentum of the heavier cotton prevents cotton from making the tight turn around the bottom of the deflector and directs the cotton towards the receptacle or accumulator. The inlet area can be adjusted or closed completely to prevent cotton loss in certain conditions.

Separation hood for a cotton harvester

Lower spiked rollers in the bottom of a cotton accumulator are inclined in the downstream direction towards an opening and rotate in the same direction to pull cotton down to the opening. An upper spiked roller located above the opening and above the last of the lower spiked rollers is only partially exposed to the cotton in the accumulator. The upper roller meters the cotton and tears apart clumps. An opening above the upper roller defines an upper discharge opening over the main discharge opening. When in a non-rotating condition, the spiked rollers act as a floor for the accumulator and prevent egress of the cotton through the openings.

Growing community of inventors

Johnston, IA, United States of America

Robert Matthew Bares