The Sherwin Williams Company

Valspar Sourcing, Inc.

Swimc LLC

Robert D Breitzman

Thomas E Reno

Owen H Decker

Carlos A Concha

Jeffrey D Rogozinski

Keith M Kirkwood

Thomas Reno

Methods and systems for coating metal substrates are provided. The methods and systems include sequential application of low flow and high flow powder coatings followed by a single heating step to provide a cured coating. The methods and systems include a marker that allows coating uniformity to be monitored and assessed during application. The described methods provide coatings with optimal surface smoothness and edge coverage.

Two-coat single cure powder coating

A representative sample of a primer and topcoat formulation (as shown in Table 5, for example) were each examined to compare their rheological behavior, with a blend of the topcoat and primer formulation (85% topcoat, 15% primer) used for comparison. The time and temperature dependence of the viscosity was measured on a strain-controlled rheometer using parallel plate geometry in dynamic mode, with an applied strain of 1% and 1 Hz frequency of oscillation. The data is represented as complex viscosity (Pa-s). For the primer and topcoat formulations, sample discs were prepared by compressing 0.3 g of the powder composition in a 13-mm plug mold at 1000 ram force for 15 seconds. Pressing was done at room temperature to avoid premature curing of the powder. The rheometer was set at 70° C. for sample loading. The gap was then set to 0.05 mm below the thickness of the pressed pellet to ensure contact with parallel plates. The temperature of the sample and fixtures were equilibrated for 10 minutes before measurements were taken. The sample temperature was ramped at 5° C./min from 70° C. to 245° C. to examine the rheological behavior as a function of temperature. The resultant curve of complex viscosity versus temperature and is examined to compare the flow behavior of the powder compositions.

Methods and systems for coating metal substrates are provided. The methods and systems include a powder coating composition comprising a polymeric binder and an application package. The application package includes at least one antistatic component and at least one post-blended component. Use of the application package reduces back ionization and faraday cage effects during electrostatic application. The described methods provide coatings with optimal surface smoothness and edge coverage.

Application package for powder coatings

Growing community of inventors

Liberty, MO, United States of America

Robert D Breitzman