Deere + Company

Robert Alan Henson

Jeffrey David Witwer

Jennifer Lynn Jaramillo

Harlin J Trefz

Neil Vincent Harber

Thomas G Bartlett

Eric R Funk

Stanley Kermit Hall

Patrick Wilson Cross

A frequency of clip control system includes a vehicle controller receiving an output from a ground speed user interface for a requested ground speed, and an output from a frequency of clip user interface for a requested frequency of clip. The vehicle controller sets the speed of an electric reel motor based only on the requested ground speed, the requested frequency of clip, and parameters of the cutting unit including the number of cutting blades of the cutting reel and reel motor to reel speed ratio.

Frequency of clip control system

A grass mowing machine for high power applications includes a controller monitoring a total implement load of multiple implements connected to lift arms on a grass mowing machine. The controller determines if the total implement load consistently exceeds available power. If the total implement load consistently exceeds available power, the controller disables at least one but not all of the implements, and provides a signal to at least one but not all of the lift arms to raise the implements.

Grass mowing machine for high power applications

An electric implement power management system includes an electronic controller that monitors total electric implement load and commands a transmission to reduce the speed of the traction drive wheels below the desired traction drive speed if the total electric implement load reaches a maximum allowable load.

Electric implement power management system

A control system is provided for starting electrically powered implements on a vehicle such as a grass mowing machine with electrically powered cutting reels. The electric motors are started at intervals, rather than simultaneously. The intervals between starting each electric motor may be based on pre-defined criteria such as a fixed time constant, voltage, current or speed input from a motor controller for each implement.

Control system for starting electrically powered implements

An electric implement lift system for mower cutting units may include an electric motor having a rotatable output shaft with a pivot bracket mounted thereto, a lift link or a pair of lift links, each lift link having a first end connected to the pivot bracket and a second end connected to a lift arm, the output shaft rotatable in a first direction to raise the mower cutting unit and in a second direction to lower the mower cutting unit. The output shaft may be rotatable in the first direction to move the cutting unit to a top/center position and rotatable further in the first direction to move the cutting unit to a raised/transport position.

Electric implement lift system for mower cutting units

An elongated air intake screen is provided for vehicles such as commercial mowers that operate in conditions having substantial airborne foreign materials that tend to clog the screen. The exterior surface of the screen is provided with intake openings throughout its 360 degree surface to draw air over a substantial area. It is located at the upper edge of the vehicle to separate it from the cutting decks and area where airborne grasses and similar foreign materials are encountered. Air drawn into the screen is used to cool the engine and hydraulic fluid heat exchangers and provide for engine combustion needs.

360 degree air intake screen

An air filtering enclosure for a vehicle to minimize the amount of debris entering the radiator of the vehicle is provided. The enclosure forms a shell having a set of interfitting interior and exterior members. Mounted with the interior member are clips designed to mate with a series of compatibly arranged brackets on the vehicle frame. Attached opposite the clips are handles which a user may grasp to easily install and remove the shell from a vehicle. Interior and exterior members form a frame which encases sheets of perforated screening to restrict the introduction of debris into the radiator. The shell is completed with a rubber seal enabling tight sealing of the enclosure to the vehicle on which it is attached.

Growing community of inventors

Willow Springs, NC, United States of America

Robert Alan Henson