Matsushita Communication Industrial Corporation of America

Richard M Stone

Earl Anthony Daughtry

Mark A Ruff

Christopher S Quire

A method and an apparatus for compensating for aging and temperature of the crystal in a crystal oscillator. An RF signal which is transmitted by a mobile telephone switching office (MTSO) (108) and received by the antenna (118). The signal transmitted by the MTSO (108) serves as an external reference. A crystal-controlled main oscillator/time base generator (134) provides a local reference frequency to the converters (120) and provides a time base signal to a counter (136). A controller (112) reads an aging correction value from a memory and provides a frequency control signal to the main oscillator (134). The converters (120) convert the received RF signal to an IF frequency. A limiter (122) provides a limited IF signal to the counter (136). Counter (136) counts the number of cycles of the limited IF signal that appear in a cycle of the time base signal. A controller (112) compares this measured count to a reference count and the count error is determined. The count error is compared to an allowable count error. If the count error is excessive then the controller (112) adjusts the frequency control signal provided to the main oscillator (134) so as to change the frequency of the main oscillator (134). Once the controller (112) has shifted the frequency so that the count error is not excessive then the controller (112) stores the new aging correction value. The measured count is therefore depends upon the frequency of the main oscillator (134) and the frequency of the received signal. This process automatically compensates for the frequency of the main oscillator (134) and, therefore, for aging of the crystal. The frequency of oscillation of the main oscillator (134) is therefore as accurate as the external reference, typically the highly accurate MTSO (108). A high precision oscillator (134) has thus been obtained using an external reference (MTSO 108) and an aging correction value.

Crystal oscillator with automatic compensation for aging and temperature

A circuit for automatically limiting fluctuations in the output power level of a transmitter by providing a feedback control signal which is based on the output power level. An RF signal (100) is input to a terminal of the RF detector (200). When the RF signal (100) is more negative than a bias voltage (209), a capacitor (208) begins charging. When the RF signal (100) becomes more positive than the bias voltage (209), the voltage in the charged capacitor (208) is added to the RF signal (100) and then averaged by the capacitors (214 and 206) to form voltage VE. Voltage VE in conjunction with the current setting circuitry (230) establishes a tail current (235) which is comprised of transistor (216) current (225) and the current from the RF detector (200). The tail current (235) tends to remain constant whereas the transistor current (225) is responsive to power changes in the RF signal (100) and represents the difference between the output power level of the RF power amplifier and the specified reference (110). The current (235) is amplified by current amplifier (220) to provide the feedback control signal (120). Thus, when the power of RF signal (100) increases, transistor current (225) decreases. This causes the feedback control signal to decrease the output of the RF power amplifier. Likewise, when the power of the RF signal (100) decreases, transistor current (225) increases. This causes the feedback control signal to increase the output of the RF power amplifier.

Highly responsive automatic output power control based on a differential

System with automatic compensation for aging and temperature of a

An automatic level control circuit for radio frequency power amplifiers which is immune to temperature and power supply induced variations. The level control circuit (42) employs a detector/comparator comprising a matched transistor pair (55) operating as a detecting differential amplifier to compare a reference signal (63) to the output power signal (83). A second amplifier (60) receives the differential output signals from the detecting amplifier and provides a power level control signal (97) to the power amplifier, thereby causing the power amplifier to produce the desired output power level.

Growing community of inventors

Suwanee, GA, United States of America

Richard M Stone