Sma Solar Technology Ag

Reinhard Lehmann

Dirk Hermeling

In monitoring an isolation of an ungrounded power grid an AC voltage source is connected to the power grid via at least one test resistor. A test signal with a periodic continuous voltage course with regard to ground and with a frequency is applied to the power grid by means of the AC voltage source. A leakage current flowing due to the test signal is measured; and an ohmic isolation resistance is determined from the leakage current. The frequency of the test signal is varied such that an active current part of the leakage current keeps a predetermined recommended value at varying leakage capacitances of the power grid. This provides for a desired level of accuracy at maximum speed of isolation or ground fault detection.

Isolation monitoring using a test signal of variable frequency

For connecting a PV array via an inverter to an AC power grid, at first a DC link at the input side of the inverter is pre-charged from the AC power grid. A link voltage of the DC link is adjusted to a pre-set value with the inverter connected to the AC power grid, the pre-set value being lower than an open circuit voltage of the PV array, and then the PV array at its open circuit voltage is directly connected to the DC link, while the link voltage is continuously adjusted to the pre-set value.

Connecting a photovoltaic array at a high open circuit voltage

For monitoring the isolation of an IT-grid with respect to ground, an inverter connecting a direct current side with an alternating current side of the IT-grid and a photovoltaic device on the direct current side of the IT-grid, at least one isolation resistance of the direct current side with respect to ground is monitored for falling below a resistance threshold value while the inverter is running, and additionally a leakage current via the inverter towards ground is monitored for exceeding a current threshold value.

Growing community of inventors

Kassel, Germany

Reinhard Lehmann