Hewlett-packard Development Company, L.p.

Compaq Information Technologies Group, L.p.

Raymond A Pelletier

Raoji A Patel

James E Drew

Brian R McQuain

Robert Wolf

A method and apparatus to layout planar magnetic coils on a PCB consists of maximizing the layer to layer overlap, and consequently maximizing total inductance for the given layout area, by spiraling alternating layers inward and outward. A further benefit of the matching opposite spirals is the ability to make the layer to layer electrical contacts within the magnetic field area, thus reducing leakage inductance, and minimizing the wasted extra conductor line length needed to make the connections outside the magnetic field. The reduced conductor line length results in reduced conductor line resistance. The method is applicable to voltage transformers and isolation transformers as well as simple inductors and other magnetic devices. In the transformer case the odd numbered layers are typically connected together in series to provide a larger turn ratio, and the even numbered layers are typically single turns (i.e., no spiral) connected together in parallel to provide more current capability.

Apparatus and method for PCB winding planar magnetic devices

A crowbar circuit comprises an over-voltage detector that monitors the output voltage of a synchronous DC/DC converter. When the output voltage rises above a predetermined threshold, the detector applies a control signal to a MOSFET switch that is already in use as part of a rectifier in the converter. The control signal overrides a periodic switching signal applied to the gate of the MOSFET, causing it to conduct continuously and thereby apply a shunt path for the output current of the rectifier. The control signal may be continuously applied until the converter is manually reset. Because the voltage across the conducting MOSFET is small and it can be turned on quickly, the MOSFET rapidly clamps the DC/DC converter's output to a voltage low enough to avoid damage to integrated circuitry powered by the converter.

Crowbar circuit for low output voltage DC/DC converters

A method of preventing current hogging in parallel connected transformers, and an apparatus for efficiently implementing the method are presented. Current hogging occurs when synchronous power converter transformers operate in a low output current mode. Low output current demands are typically meet by adjusting the duty cycle of the transformer to a low level. This results in the catch FET maintaining a low resistance path to ground for long time periods and allows a stronger one of the parallel power converter transformers to sink current to ground through a weaker transformer. The method consists of using a current sensor to detect low or negative output currents, and then driving the transistor providing the path to ground to an off state. A preferred embodiment of an apparatus to prevent current hogging includes a current sense inductor placed in series with the primary side of the power converter connected to an operational amplifier having an input reference voltage selected to provide an output when the current sense inductor records less than a certain positive voltage. The op amp turns on a driver to force off a transistor which normally conducts to ground when the duty cycle is in an off state.

Growing community of inventors

Goffstown, NH, United States of America

Raymond A Pelletier