Pason Systems Corporation

Quinn Harrison Hepburn

Trevor Leigh Holt

Choon-Sun James Ng

Thomas William Charles Wilson

Sean William Scotvold

John Aaron Eddy

Thomas William Wilson

Methods, systems, and techniques for controlling the rate of penetration of a drill bit are described. In particular, an operate control loop is evaluated by: determining a travelling block acceleration of a travelling block; determining an acceleration error measurement between the travelling block acceleration and a target travelling block acceleration; determining, based on the acceleration error measurement, a brake control signal; and using the brake control signal to control a braking mechanism configured to apply a variable braking force to the travelling block.

Method, system, and medium for controlling rate of a penetration of a drill bit

There is described a method of controlling a drilling operation. A pipe joint is determined to be entering a rotating control device (RCD). In response to determining that the pipe joint is entering the RCD, a weight-on-bit (WOB) setpoint is increased so as to increase a measured WOB. After increasing the WOB setpoint, the pipe joint is determined to be exiting the RCD. In response to determining that the pipe joint is exiting the RCD, the WOB setpoint is decreased so as to decrease the measured WOB.

Method of controlling a drilling operation, and rotating control device mitigator

Methods, systems, and techniques for controlling the rate of penetration of a drill bit use drilling parameter measurements read from drilling parameter sensors to evaluate control loops, with the output of one of the control loops at any given time being used by an automatic driller to control the rate of penetration. For each of the drilling parameters, the automatic driller reads a drilling parameter measurement, determines an error measurement that represents a difference between a drilling parameter setpoint and the drilling parameter measurement, and from the error measurement determines an output signal proportional to the rate of penetration of the drill bit. The output signal of one of the control loops is subsequently selected and used to control the rate of penetration.

Growing community of inventors

Calgary, Canada

Quinn Harrison Hepburn