Lucent Technologies Inc.

Piet Van Heyningen

Yong-Kwan Park

Kyeong-Soo Kim

Reed K Even

Song Jiang

Woojune Kim

Peter Van Eijk

Fengkun Liu

An optical network has an optical splitter connected to (1) a working optical subscriber unit (OSU) of a working circuit via a working optical fiber, (2) a protection OSU of a protection circuit via a protection optical fiber, and (3) one or more optical network terminals (ONTs), where the protection OSU has a protection burst mode receiver (BMR) configured to receive an upstream optical signal from the optical splitter. The algorithm determines whether the protection OSU is functioning improperly. A reset pulse is applied at the protection BMR at a particular timing position and an attempt is made to interpret the current upstream cell received at the protection BMR. This process is repeated using different timing positions for the BMR reset pulse until the current upstream cell is correctly interpreted, e.g., based on the correct identification of an ATM header error correction (HEC) byte in the upstream cell. If, after a specified number of cycles, no upstream cells are correctly interpreted, then the protection circuit is determined to have failed. In one embodiment, the algorithm is based on a cell delineation procedure implemented as a state machine.

Health check algorithm for protection circuit in optical network

An optical network has an optical splitter connected to (1) a working optical subscriber unit (OSU) of a working circuit, (2) a protection OSU of a protection circuit, and (3) one or more optical network terminals (ONTs), where an ONT has (i) a working line termination (LT) unit of the working circuit and connected to the optical splitter via a working optical fiber and (ii) a protection LT unit of the protection circuit and connected to the optical splitter via a protection optical fiber. The present invention enables fast protection switching from the working circuit to the protection circuit. The arrival times of corresponding downstream cells are measured at both the working and protection LT units of the ONT, and information related to the arrival times is transmitted from the ONT to the protection OSU. A propagation delay value is generated based on the transmitted information for use by the protection OSU for communications with the ONT if and when protection switching is implemented upon detection of a failure in the working circuit.

Fast protection switching by snooping on downstream signals in an optical network

Growing community of inventors

Almere, Netherlands

Piet Van Heyningen