Vertiv S.r.l.

Chloride Srl

Pier Ugo Costa

Graziano Galuppi

Marco Bonora

Matteo Tricarico

Enrico Guidotti

Andrea Pettenò

Donatella Zaccheroni

Paolo Mistroni

A method of controlling an uninterruptible power supply system to increase component life includes decreasing a maximum output power limit of the uninterruptible power supply system when a temperature that the uninterruptible power supply system is experiencing has increased and increasing the maximum output power limit when this temperature has decreased. In an aspect, this temperature is ambient temperature of an equipment enclosure of the uninterruptible power supply system in which at least a rectifier and inverter of the uninterruptible power supply system are located. In an aspect, the method further includes upon the system going into an overload condition, determining an overload time limit based upon the temperature, the overload condition and an initial load condition. In an aspect, the method further includes upon the system going into a back-up power mode, determining a battery autonomy based upon the temperature.

Method of controlling an uninterruptible power supply system to optimize component life

A method is provided for communicating data amongst controllers in a power supply system. The method include receiving a present measure of a parameter indicative of an operating state of an uninterruptible power supply (UPS); comparing the present measure to a control window for the parameter, where the control window defines a minimum value for the parameter and a maximum value for the parameter; updating the control window based on the present measure when the present measure falls outside of the control window; and transmitting the present measure via a controller area network to a managing controller when the present measure falls outside of the control window.

Techniques for communicating data amongst controllers in a power supply system

A UPS system may be operated selectively in either a high efficiency mode or a low efficiency mode. An inductor is connected in series between the transfer switch and a secondary power source. The transfer switch includes thyristors arranged in a reverse connected configuration. A controller synchronizes gate commands to the thyristors in order to synchronize reserve voltage introduced by the inverter. If the load currents are not in phase with a fundamental voltage of the secondary power source, the controller waits up to a first time period in order to estimate when current through the switches will reach zero. If the out of phase current will reach zero by the end of a second time period, the inverter is switched on at the end of the second time period.

Uninterruptible power supply system with fast transfer for undervoltage source line failures

Growing community of inventors

Imola, Italy

Pier Ugo Costa